The Strix Stix Li-Ion battery pack is perfect for most FPV goggles. They are even a perfect fit in the FrSKY Taranis Q X7 transmitters! They are equipped with special circuitry to avoid over charging, discharging, and balancing. Be sure to set your charger to cutoff voltage at 4.20v per cell (8.4v total) to achieve a full cycle.
A**.
Using to replace EV200D battery
My EV200D battery was annoying me with it's usb charge and barely lasted more than 10 minutes. The cable on this one is shorter, but it's light enough I can just stuff it into the side of the band. The balance lead made me feel better about charging it on my lipo charger. I was able to make an adapter in about 3 minutes with an XT60 connector and barrel plug leads so I can just charge it on the same home and field ISDT setups I have for my quad batteries. The only downside is that the cells aren't discharging very evenly, about .05v difference after usage between a few days sitting. Not a big deal on goggles, and they balance out full charging with an ISDT unit so not a deal breaker for me, but I would definitely avoid charging this without the balance leads. I'm getting about 5 times the longevity compared to my stock EV200D battery, but that's probably more a testament to how bad the eachine battery is.What I used for my XT60 adapter (you'll have some leftovers, soldering required):https://www.amazon.com/gp/product/B075Q91XJ5/https://www.amazon.com/gp/product/B01ETROGP4/update: note - there's no voltage cutoff. Mine ended up bricked when someone left it plugged in.
K**.
Battery was shipped depleted down to 7v, Cell1 won't fully charge.
Upon receipt I put on charger. I found that the battery had been shipped with each cell at 3.5v. Way too low for LiPo. Because of that both cells are mismatched and one is bad. Cell1 has an internal resistance of 61mOhm, Cell2 is at 31mOhm when first checked. After 2.5hrs of charging, Cell1 will not come up to a full 4.2v and has been struggling for over 30mins to reach 4.2v while Cell2 has been there. I think this battery was overly discharged and not properly handled. Cosmetically it is fine but Cell1 won't reach 4.2v (more like 4.17) and after charge Cell1 was 61mOhm and Cell2 was 37mOhm. This is a bad battery. Not sure if others have this problem but I plan on returning it for another one.
J**N
Works great but the only downside is that the 2s plug ...
Bought this battery for use with the Aomway Commanders. Works great but the only downside is that the 2s plug doesn’t connect into the 2s slot of the aomway battery filter so I use the barrel connector on the battery which still works but I had to modify the straps to hold the battery closer from where you normally place the battery on the Aomway. Other than that though love the battery.
S**C
1-1.5C Charge rate
Charge rate is 1-1.5C max. Zzzzz.I cut off connector and FYI the round black wire contains a red and black insulated wires inside it.Easy to stick a JST connector in line. Cut the black insulation away carefully. Then cut the wires one at a time to prevent a short.
N**T
Great battery!
Great battery!! I have been using this with my Eachine EV100s with DVR and it works excellent, stays cool and provides great battery life. Balance plug plugs right into my DVR to power it and the goggles without any adapters!
A**.
Great LiPo Alternative
The battery life of this pack is very impressive. It noticeably drains more quickly than a LiPo of it's caliber, but the longevity you get for the price exceeded my expectations.
D**L
Excellent quality FPV goggle pack
Excellent quality FPV goggle pack. Charges up to full capacity (note - using the barrel plug only!) and holds a decent charge for quite a long time. Definitely recommended!
D**A
The best battery for your Remote
This battery las long in your remote, I use on my Taranis Q-X7, is great!!
Trustpilot
2 weeks ago
2 months ago
