Big RED AT830003XLUR Economic Aluminum Quick Lift Low Profile Garage Jack, 3 Ton (6000 lb), Blue

This floor jack it’s very light and I use for my lawn mowers trailers and trucks

The fit and finish on this jack is amazing. All the welds seem nice and sturdy. It's great that all four wheels are also aluminum. It is extremely light and maneuverable.You can easily rotate it on my garage floor without even using the wheels. The jack raises and lowers smoothly. It only take about 4 full pumps to get my cars tire off the ground. It really shines with lowering though, it is easy to drop the vehicle nice and slow. I like that the pad where it contacts the vehicle is wide as it seems to spread out the stress on my vehicles frame. I hear much less creaking and groaning than my other jacks. The handle is also aluminum and comes apart into two pieces for storage. You can easily pump the jack with only the bottom half of the handle. This is necessary for me because I don't have enough space to pump the full handle with two cars in my garage. The instructions with the jack are lacking. This is not really a huge issue, except I did not realize that there is a thumb screw on the bottom that holds the handle in place. You cannot fully insert the handle without first loosening that thumb screw. In conclusion, this is definitely a good choice if you are looking for a mid range floor jack. It stacks up just fine with the other brands in the same price range. It seems repairable and I have no doubt that it will last for a very long time.

I have a few older steel jacks, between the weight and noise they are annoying to use. I wanted a lighter aluminum jack that would be easier to move and faster, this is both. I put the handle on and off to work it went when I had to rewire my trailer brakes. It's about 4200lb and I had no issue lifting it by the equalizer. About 2 pumps and the lift pad was up to the equalizer which is a nice change from the probably 10+ with the old jacks. The wheels roll easy, had no issue with my less than clean floor. I don't see any grease zerks, so you will have to occasionally tear it apart to grease the pivot points. the pump roller did have a fair amount of grease on it out of the box. Only thing minor thing I have found is that it doesn't like to fully retract unless you turn the release way out.

Low profile (lowered vehicles), quick lift, and fairly lightweight considering capacity. Coming in at 56lbs, this is much lighter than pittsburgh/daytona models from harbor freight. 3T lifting capacity, good hydraulics, and smooth rolling. Great primary home, or shop jack. Just for reference a similar 1.5T aluminum, quick lift jack weighs in approx 33lbs, so for double the capacity for another 23lbs weight is very reasonable.