🚀 Elevate Your Ride with SumoSprings!
The SSF-604-40 SumoSprings are a high-performance suspension upgrade for Toyota and Lexus models, designed to enhance load carrying ability and stabilize sway. With a remarkable 1400 lb capacity at 50% compression, these maintenance-free springs are made in the USA from patented microcellular urethane, ensuring superior ride comfort and control.
| Manufacturer | SuperSprings |
| Brand | SuperSprings |
| Model | Solo |
| Product Dimensions | 27.94 x 20.32 x 12.7 cm; 1.05 kg |
| Item model number | SSF-604-40 |
| Manufacturer Part Number | SSF-604-40 |
| Special Features | Improves overall driver control and ride comfort, Progressive spring rate with superior damping properties, Compress up to 80% of original height with full memory rebound, One-piece unit attached on one side used as a replacement/upgrade to factory bump stops, Made from proprietary and patented microcellular urethane |
| Item Weight | 1.05 Kilograms |
G**L
Cut 1/2 inch off the stud
The stud was too long to allow me to install the SumoSpring on my non-lifted 2021 Tacoma TRD Off Road which was jacked up with the tires off the ground. I test drove my Taco over a known dip and the results were remarkable in that compression of the front suspension was much smoother, no harsh bottoming out like with the stock bump-stops. While it was up . . . I applied a coat of AT-205 Re-Seal to all four Axel Boots to promote longevity.
M**S
Not a perfect fit
Had to cut half the thread off before I could attempt to install it. Original bump stop thread was as long as what I ended up with. Truck jacked up to give the most room for install I still had to tap it in compression of the sumo spring on one side of it to align it to thread in. Both installed this way. End result they are in compressed one third when parked (always touching) however the ride has improved. My guess there more universal size for vehicles.
J**W
Requires cutting
Requires slight cutting to install but overall easy and worth it
A**R
sumo springs
they work well evened out the ride i would buy again
B**K
Happy So Far
Installed on my 22 Tacoma ORDCLBInstallation was not hard but definitely didn’t just throw them in. I did have to cut about 3/8 off the stud due to a not wanting to dismantle to install. Used a mini hacksaw to do a reasonably controlled cut. And also used the supplied nuts to check the thread after cutting. Take your time and you’ll be fine .
Trustpilot
2 weeks ago
1 week ago