Winjet Kit-N Wiring Kit - Fog Light Switching Relay, Black, KIT-N

Had never used a wiring harness before this. Took a bit to figure it out for the first time, but it was really, really easy to install and run the wires. All components and wires are of a high quality. The installation instructions (or guidelines, I looked up clearer directions online) are printed on the back of the box it came in, just an FYI. No complaints, it is simple and easy to use.

The build on this harness was almost solid. All wires were heat shrinked properly, no open copper wires anywhere, inline fuse was solid, and included switch worked out the box with no issues. Zip tying the wires out of sight was difficult (only because there was very little room to work in my engine bay. I ended up cutting the wires of the current switch provided and soldering those wires to a separate switch (Daystar KU80011 20 Amp Blue Light Rocker Switch Kit). Even with that switch I am getting no feedback (of a ground loop, even with an aftermarket system). Just make sure everything is properly grounded and it will work with no problems.**Word of advice.... If you are going to using a separate switch as I did, be careful with the wires as there is roughly only 5-6 strands of copper and a lot of coating to protect those wires. I ended up stripping all the copper and having to start over once because of this.

Ease of use, very well put together. The switch it comes with needs to be replaced, it's to flimsy but harness is great.

Bought two of these to run auxiliary lighting on my truck i.e. Spot lights and light bar. I wish it could handle more power but 100 watts is about the most I'd put through these safely. Comes with wiring diagram and the installation is easy with minimal electrical knowledge. I cut off the push button switch that came with it and wired in a toggle but that's just personal preference.

Easy to install and works just fine. Don't like the fact that the swithc button has a red light on when the lights are in the off position. I can see having the green light come on when the lights are on but why in the world would you need a light showing it's off??? I put this on my Rhino and it drains the battery unless you ride every day. I have to unhook the harness when I'm done riding. Lookin like I need to hook up the switch to my ignition so the off light comes on only when the key is on... Other than that, it's just fine.

This made an additional rear light set up easy on my Polaris Ranger I used another switch but this one could have worked. Perfect for what I needed it to do. Do your homework and make sure this is what you need. Much better quality than the one I saw at Walmart.

Ordered two to wire my lights and they are great for off road lighting needs. The only issue is the cheap little on/off switch they have attached, which is why I ordered two additional switches. Only drawback is that the split is not long enough to cover both directions in my application, but that's easily solved with adding additional wires.

Button cover popped off and button circuit is now open to weather