Kendo10-Pack 7-1/4 24T Inch Carbide-Tipped Circular Saw Blade with 5/8 Inch Arbor, Professional ATB Finishing Woodworking Miter/Table Saw Blades for Plywood, Laminate, Ripping Wood

OK, I will admit it: I bought these blades because they are inexpensive and I had made some drawers that had 23 gauge pins in them that I had to cut down. Rather than take the chance ruining a good blade, I figured worst case I will ruin a $10 blade. I put the 60 tooth version in my table saw and I was absolutely amazed by the quality of the cut I got, both on melamine faced particle board, and the drawer stock. As I fed the drawers through the blade I did see a couple of sparks (probably a result of cutting through the #23 pins) but the overall quality of the cut was superb. After cutting the drawers I continued to use the blade to cut that 3/4" melamine faced particle board and the results were equally wonderful; virtually zero chip out that I can see on the melamine. I cannot vouch for long term usage since I have only used the blade for a few days but I am incredibly impressed by the quality of the cut I got for such a low cost...I'm a happy camper and have no reservation about recommending the 60 tooth blade. I have not tried the other yet. Attached is a photo of the melamine faced particle board just cut with this blade.

Good value. Cuts well

I haven’t tried them yet but they look good and were so reasonable I had to try.

Only used to rip about 5 boards so far. I was impressed with the cut so far. New to wood working so I can only compare to what I had in blades and the cut was smooth and there was np burning or struggles to cut the boards. I'm impressed.

Cuts good, fast and clean!

Great blades, unbelievable price .Hope they hold up as good as they look

It's a decent blade, I use my table saw like once a week (mostly ripping cedar and pine) and this things is holding. Idk how it would hold up to daily use or on hard woods but its doing just fine for me, I need to replace the blade on my miter saw and I'm probably going to repurchase this blade when I do.

It worked fine good price