Supershieldz (2 Pack) Designed for OnePlus 7 Pro and OnePlus 7T Pro Screen Protector, High Definition Clear Shield (TPU)

This is my third time buying these as I'm still rocking the 7 pro. This flexible skin is my favorite type. The best if your phone has curved edge. I actually enjoy doing the application as they include everything you need to get it perfectly aligned and have zero dust or bubbles. Do watch the short YouTube video they suggest it makes it all make sense and the install will be much easier. These are good quality and good value, and they last a long time and my phone operates very smoothly with it on.

Good but little difficult to get all bubbles out and I’m pretty good at putting these on

So affordable it's almost like stealing! Ease to apply (and has instructions for noobs. Sticks well. Ease to replace. Thickness is good, not bulky. Durable against falls, drops, slips, and the ever so present toss-on-bed-then-bounces-to-floor scenario we all wish we weren't familiar with. Screen stays safe against the occasional gravel/concrete skid.

I followed the instructions carefully and was able to replace the original screen protector that my phone came with with this Supershieldz HD Clear protector. I had to use the sticky tape over and over to make sure no dust particles got underneath. The protector fit over the glass screen perfectly, as long as you align it well. No bubbles I can see sticking up. I'm happy with this replacement.

I would give this 0 stars if I could. Used both screen savers and NEITHER went on even though I followed the instructions exactly. The instructions I received were actually for a different screen saver and different phone and it DID NOT WORK for my phone. Now I have a bubbled, twisted mess on my phone and have to order something else!

So the colors look great with glass instead of TPU. But unfortunately the glue is not enough to keep it in place. The round edges of the phone makes it harder to align it properly. So, when you use a hard case for protection, your bound to pop the screen protector off. Here's the best thing to do: Set your background for the lock screen to a gray color. It will allow you to see the icons and speaker better so that you don't cover them with the glass. Set the display timeout to at least 5 or 10 minutes. Of course during placement, you have to turn the phone on, but you don't have to unlock it. Follow the instructions, and try as best as you can to align it below the top speaker and that the edges are leaving the same amount of space on both sides. If you fail take off, and try again. Pay close attention to the dust, because every time you remove it, dust can land on the phone screen. And be careful with every alignment, because dust can be trapped on the glue inside the glass. You can't remove that dust, you just smudge the inside. And my best tip: when you got it set, use a blow dryer hot air and heat up the glass. The point is to get the glue to soften. And have a clean cloth ready to press down on all areas of the glass. Heat it up again if you have to and repeat the process. Make sure the glass doesn't move off, so be careful in the way you press it down. Put pressure on the edges as well. The glass and glue separation from the phone screen makes a sound, can't describe it but you'll know. Heat up those areas or the entire screen again and press down. Good luck 🤞

Clarity

Fits well, but sometimes it's not sensitive enough to fingerprint to unlock the phone