Bullet Puller

I teach a reloading class, and part of that class is to demonstrate how to safely disassemble cartridges (the ones that might have been improperly assembled). So, this tool gets used a LOT. My previous one broke (Lexan plastic finally gave up from all the pounding), and I had used it so much that I wsn't going to try to ask the manufacturer to replace it. So, bought an exact replacement to what I previously had, and expect that this one will last for years and years and years, just like the previous one did. So, buy with confidence. A great price for a great tool.BTW, a couple of tips for using the tool:1) Always use the correct size collet (they give you a whole set of different sizes when you buy the tool) for the cartridge you are going to disassemble.2) The rounded part of the collet goes towards the plastic nut. If you install the collet backwards, you will rip the lip off the collet. Rounded part towards the plastic nut.3) No need to over tighten the plastic nut. However, you don't want it loose either. Just snug is fine.4) Do not whack this tool on any metal objects. I strongly suggest that you use this tool on the end of a piece of 2X4. If you hit it on metal, the plastic will shatter, and you could get injured. The end grain of a 2X4 properly absorbs the impact, allowing he tool to work properly.5) Always wear safety glasses during the use of this and all tools. The tool may be replaceable, but your eyes are not.

Works nicely.

Works well and is very durable but I hope you can swing a hammer. So far I've broke down 12 30-06 rounds. Took a good bit longer than I expected and I split my 2x4 in half and continued with each piece. As I said it works but you better be able to swing a hammer.

It works as advertised. Great price. Get one in case you ever need it. Worth it the first time I used it.

Great product and I love the price too!

This works like any other kinetic puller. I was disappointed with the little foam cushion. I pulled a few dozen 30 cal rounds and about halfway through the pad inside disintegrated. If I was paying closer attention I would have noticed and figured something out. As it was I did not notice the fragments of the padding come out and all the bullets I pulled after that were pretty messed up from smashing soft points inside unprotected the puller. Sort of defeats the purpose if the bullet is damaged in the process

Price was great and saved me from having to go to a gunsmith! It was worth it for sure!

Takes a moment to get used to, but once you get the hang of it it's a breeze to use.