ELEGRP GFCI Outlet 15 Amp, Self-Test GFI Electrical Outlet with Thinner Design, TR Tamper Resistant GFCI Receptacle, Ground Fault Circuit Interrupters with Wall Plate, UL Listed, Matte White, 1 Pack

ELEGRP's matte white is very close to Lutron's satin Snow, only very slightly lighter and less pink. The texture grain is finer than Lutron's, but I don't notice that difference unless I'm less than 40cm away. ELEGRP is 1/5 the price of Lutron, but it looks nicer than Lutron's GFCI outlets, because it has 1 small rectangular LED in the corner instead of 2 big round LEDs in the middle. The surface looks perfectly flat to me, without any warping or other injection molding artifacts.Like other GFCI outlets, it protrudes more than non-GFCI outlets.

I got this setup to replace my old ivory plug and switch and to match my bathrooms fixtures. For the price you pay these are great to use and work great. They come tamper resistant and are UL listed. The led indicator light works as it should turns green when on and turns off when tripped. It was an easy swap from old to new and the screws matched the length of my old ones. I also went to their visit store and it made it easier to order the other things I needed because they have all their products listed and it makes it easier to color match. Highly recommend getting the screw-less covers because in my opinion they look so much better compared to the regular ones.

Easy to install. Well made. Liked the smaller profile and that it came with a matching bezel.

Gorgeous outlet that unfortunately did not work. It happens sometimes. I will say we fully appreciate the sleek design and ease of installation. The outer cover clips in rather than screwing on, which makes it especially appealing.

Easy to figure out how to install yourself has good instructions included with it. Looks really nice.

Replacement for the bathroom. Turn off the breaker before replacing

Junk. I've replaced many many duplexes over the years. Bought this GFCI because that's what my Traeger suggested. Reset button wouldn't 'click' like you should hear when you reset it. Had 120v @ wires but zero @ the plug. Swapped wires to the other outlet, zero. While it was pulling it out to reinstall the other non-GFCI outlet, it clicked. Now 120 @ the plug. Left it, frustrated @ this point. Have no faith in the GFCI function, will replace it tomorrow. When something is priced a half of what you should pay, don't waste ur money. Knew better, but just retired and was trying to save $. Never again! POS, don't buy it.

This was obtained in order to repair a damaged GFCI outlet in the restroom. The wires are linked in a very conventional manner, and the holes are aligned. completed it in ten minutes. The 'breaker' has so far been effective. We'll just have to wait and see how long-lasting this is. However, I'm happy with the buy thus far.