Carburetor Fits Yamaha 1987-1990 & 1992-1995 Moto-4 350 YFM350 | 1987-2004 Warrior 350 YFM350 | 1987-1998 Big Bear 350 YFM350 | 1996-1998 Kodiak 400 YFM400 Atv Carb with Bolt Air intake Manifold

Installed this on my 1987 yamaha moto 4 350cc. Works great!! Turn key right out of the box the air to fuel was set at 3 full turns out from bottom. Will work on big bear 350's as well it's the same engine

Seem to be the correct parts, haven't had time to replace them

Installed the carb in an ‘87 yamaha warrior. Initial installation went good. Seemed like decent quality. Everything went well until I started the warrior, and fuel began running out. After tightening the drain screw it seemed to stop until I ran it again and same issue. The screw does not seem to be seating correctly. It leaks, everytime, without fail. Would love to send it back but it’s kinda inside the warrior so… little hard to just put it in a box and send back.Needless to say, I am not very impressed with the carb.

Bought for 2002 Yamaha warrior 350 to replace old mikuni carb. Fit perfectly other than slight modifications. Throttle cable inlet was too long and bend was too sharp. I cut about an 1/8in before the threaded portion (see pics) then heated with torch and bent upwards to match angle of old carb. THEN had to tap out the hole where the throttle bracket goes so the old screw could old bracket on. AFTER those minor mods, everything bolted up perfectly, started up instantly with a little choke and idled perfect with out adjustment. 4 stars because of the mods needed to fit on warrior.

I installed this on my 1988 Yamaha Terrapro 350. It fit Great and Runs xlnt. Great price, new carb from Yamaha was over $400.

Carburetor fit, was close to the right tune. The hardware wouldn't fit, and the intake boot tore down the middle after half a day of riding. You get what you pay for, so buyer beware.

I replaced a 6 year old carburetor on my 1998 Yamaha Big Bear 350 (original owner) with this unit. It cranked as soon as I engaged the starter and runs smoothly. I paid $10 less for this unit than for the one that I purchased 6 years ago. I One week later, I ordered 2 more units for future replacements and have them stored in a cabinet along with other replacement parts. I couldn’t be more pleased.

Not the best quality, the gaskets were put on incorrectly so the bike leaked gas every where

The media could not be loaded. Bolted right on works perfect with zero adjustment

The media could not be loaded. My OEM ive rebuilt twice now and just would always die after a while of idling no matter what i did, decided to give this a try and quality is just lile the OEM and bolted right on with zero issues! Its basically a bolt on and go as i had to do no adjustments! Very happy and highly reccomend!

Terrible casting and came damaged bottom bowl screws were already stripped throttle cable cover was broken save your money terrible product bought for warrior 350

Carb and parts work great, missing the gasket for the carb, spark plug was wrong size, but everything works good once installed, don’t lose any parts cause you don’t get extras.

All was good and bolted right on