XPEL Clear Paint Protection Film Roll 6" x 60" – Self-Healing, Non-Yellowing Polyurethane PPF Wrap Protects Paint from Chips, Scratches & Road Debris | Invisible Shield for Cars, Trucks & More

Film is much thicker and of a higher quality than I had expected. I have never applied a protective film before. It is firm but does stretch a little and has some give. Watched a few videos and gave it a shot. For the slip solution recommendations were for 2ml baby shampoo per 32 ounces of distilled water. I found it better with 2.5 ml or 1/2 teaspoon and 24 ounces of water. It allowed a little more slip and forgiveness for a beginner. For the tack solution recommendations were not to exceed 17% alcohol so I used 150 ml 91% isopropyl alcohol to 850ml of water, Or 3 ounces of alcohol for every 17 ounces of water. This ratio worked well for me to tack corners. I found the application fairly easy on flat or slightly curved areas. Once applied it is very hard to see and has similar gloss to car. Looks very good. Squeegee worked well. Just the right stiffness for me. Due to my inexperience had difficulty on sharp corners and different angles. Material was forgiving, was able to remove and reapply fairly easily. Recommendations were to wet hands thoroughly with skip solution, clean area thoroughly and wear lent free clothes. I did have some issues with small pieces of lent/dirt on white car. If I noticed in time was able to pull film away and flush out with slip solution. Would definitely buy again. I may even try to do the hood. I also applied to inside of cup holder and seems to be working very well. Metal cups were scratching the plastic. I don’t know what other films are like so nothing to compare to, but this seemed like a very good product. Hope this helps.

Great..

The product is shipped in a plastic container with a squeegee to apply the film which helps reduce air bubbles.. It is one piece which can be easily cut/modified with a scissor or carpenter's knife. Application of this product is tricky. Use large volumes of water while using your hands / included tool to ensure air bubbles are reduced. I believe the product will protect my front hood from chips caused by stones. I totally expect this to be replaced in the future because of the amount of debris that my truck incurs. I found it easy to redo sections that had air bubbles making sure I added plenty of water each time. As a novice, I achieve what I think was acceptable results. I would recommend this product. The price point is low enough to provide enough protect and not be unsightly.

Bought to hopefully preserve lights on car. Easy to apply. Clear and no distorting. No idea yet whether they will protect against chips or damage.

good quality, good protection and adhesion, when price goes down will buy two more for the second car

Not sure why people are saying it’s very hard to install, surprisingly for me, it was one of the most easy installations I’ve done. I didn’t use it for large areas, just used patches on dings in the clear coat or paint to stop water from getting under clear coat and to ensure that the dings didn’t progress. Pretty much invisible, unless you look very hard. Make sure you cut your sizes liberally, and clean the application area thoroughly with isopropyl alcohol. Then make sure you spray lots of soap water on the application surface and the adhesive part. It helps to spray the adhesive side when you start peeling it off the paper. Give it another few sprays so the squeegee can move across it easily. So far, 10/10. Will update as the film ages.

It’s hard to say which is more disappointing, Xpel the company or this film. I had an unfortunate situation where removal of the film peeled off sections of clear coat from a new bicycle (see photos of the removed film and the damage it did to the paint). I followed best practices for installation and removal, so I am confident there is a problem with the adhesive on the roll I used. I reached out to Xpel regarding the damage caused by the film removal and they were quick to dismiss any responsibility. They went so far to say: “So our warranty only covers defects of the film itself” Essentially, Xpel is saying they only cover the look of the film. Implicitly, they are saying the adhesive is not part of the warrantied product. As the film is only usable for paint protection if it can stick to and be removed from paint without damaging it, Xpel is selling a product for a purpose they are unwilling to stand behind. Xpel has further stated: “Our PPF is designed specifically for automotive paint, if the film is installed on anything other than automotive paint there could be issues with the removal of the film pulling paint.” At the time of purchase and posting of this review, the product packaging mostly describes all the use beyond automotive for this film (image included). Xpel isn’t even willing to acknowledge support for use cases it goes above and beyond to market. Moreover, they fail to inform consumers of the additional risks when using this film for anything but automotive purposes. I implore you to learn from my pain and see Xpel and this product for what it is, unfit.

Used on set of fog light this will extend life of covers strong easy to work with use heat gun for extra stretch. sticks well on fog lights can be used for almost anything good price clear good visibility

貼りやすいしお勧めです。貼り方はユーチューブでも紹介されていますが、水をたっぷりつけて施工してください。 ただ、ゴム手袋は必須です。手の指紋がつく可能性が高いです。指紋がついたら目立ちますし、とれません。 私はヘッドライトに施工しましたが見事に指紋が付きました。気になりますがもったいないのでそのままです。

Easy to apply and virtually invisible.

Goes on great with the gel Happy.

Excelente producto. Recomiendo aplicarlo en la sombra en un día soleado.

This was sold as an 84 inch roll of protective film however after I had started using it and realising that it was running out very quickly I measured the full roll and it’s only 60 inches.