Silicone Mold Making Kit, 10A Super Elastic Jade Green Platinum RTV-2 Liquid Silicone Rubber 2.6 LB for Casting 3D Silicone Molds, Resin, Soap, Candle Wax, Plaster, Clay, DIY Molds - 1:1 by Volume…

Likes :Very easy mix and pour. This products does degas itself incredibly well. I like that it is sort of clear as well. There are absolutely NO bubbles in my mold.Dislikes:It takes about 4-5 days to really cure to be able to use the mold. It is a little more flimsy than the kind I usually use but it still works if you put it on a hard surface and don’t move it while things are casting.

Very easy to use. The mix ratio is 1:1 which I always prefer. You can mix equal amounts into two cups. I used a scale and a larger cup and mixed it that way. Be sure to mix thoroughly. Have the item you want to mold already prepared. I pour from one area and allow it to flow over the item and fill. I do not move the silicone around as I pour. Not sure if it matters but it works for me. I can not say hold long to it takes to set up as I do this in the afternoon and leave it overnight. The other bonus is that it's translucent. If you create with UV resins this may matter to you. Do not try a deep mold with UV resin unless you cure it in layers. If the silicone mold is a solid color it will not work for UV resin.

I’ve never made a silicone mold before and this was super easy to use. My only complaint is that, like others have said, the product leaked in shipping but only a very small amount from one bottle so I was still able to use the product. I didn’t measure each part before I mixed because I needed the whole entire bottle at once. It came out perfectly! I would definitely use this product again.

Best product I’ve used so far

This showed up in a box with another Amazon perches. It was in its own box inside the Amazon box and it was a thin box when I opened it everything looked fine until I opened the lid of part A. The seal had popped and some of the liquid was in the lid and it made a huge mess. After cleaning it up I contacted the seller. They were very fast to respond and offered to send new ones out. It showed up in 5 or so day's but the problem was they shipped it in the thinner box. This time it didn't have a bunch of liquid in the caps but there was some that leaked out. Enough that there was a film on the outside of both bottles. Other then all that I made mold of a figure and it seemed to work very well.

Well packaged (triple closed bottles). Timing as stated was perfect. Colored using https://amzn.to/3Bihxf8 no silicone release spray used, 3D printed and lazily sanded “paper weight mold”.

This stuff is garbage. Ruined two of my projects because of how sticky the final result is. There are much better options elsewhere on Amazon. Don’t buy this stuff.

easy to make mold.does not stick when unmold.a bit expensive but worth it.convenient the color when mixing to make sure the 2 liquids are completely together.