AmeriLite for 2011-2013 Jeep Grand Cherokee WK2 LED Tube Black Replacement Tail Lights Assembly Set - Passenger and Driver Side

Awesome I really like them

Upon install the passenger side blinker light was out. No huge deal and would have just asked the seller for a new bulb to try but issues with the tailgate/inner light on the driver side were far more concerning. As I was tightening (by hand mind you) 3 of the 4 bolts snapped from the housing making it impossible to install and difficult to remove. The metal bolts are simply screwed into the plastic housing with no metal insert to prevent stripping/breaking. Really poor design/manufacturing. Always a bit of a risk going with an affordable like this but was really disappointed. They look great but I would definitely avoid.

Easy Install, some Hiccups. The quarter panel assemblies are very easy to install. Two plastic pull out pins will allow you to separate the assemblies from the quarter panel, then two cables to disconnect. Not sure if my wiring was OEM or modified as I had an extra component that resembled a heat sink, but regardless, the cables plugged into the new units as advertised. Secondarily, there is an additional electrical unit that feeds in/out of the new units. Not sure of its purpose, maybe to increase resistance as LEDs have lower resistance and can cause performance issues because the circuit is being fooled. I however ran into a small issue: One of the pins in the new R/H unit was either shipped to me bent, or I bent it when I was plugging the cable in. I will assume I bent it and it was an easy fix to straighten it. Make sure your pins are straight or you may break them or have performance issues when you go to test the units. The hatchback units will require more tact and involvement. You will have to remove the interior hatchback panel. There are about a dozen or so plastic pins that offer some resistance to holding the panel in place, but should come off relatively easy. Be gentle when removing the panel. There are four nuts to each hatchback unit that are 10mm. Easy removal of the nuts and units. Easy install as well. When all parts are reassembled, close your hatch slowly and watch the edges where the quarter panel unit meets the hatchback unit on both sides. They may collide or interfere with each other. Simply remove the pins for the quarter panel unit(s) and readjust them so they are deeper into their indexing points and any gaps present are closed up more than before.

Easy to install, great upgrade.

2011 Jeep Grand Cherokee Limited The lights look great & seem to be good quality, I just installed them so if any issues come up, I'll report back here.