X 135 FPV Drone Frame Carbon Fiber with 3mm Arms, Freestyle X Frame Quadcopter Kit for 1104 1105 1106 1306 Brushless Motor (Suitable for 2'' 3'' propeller ) by Crazepony

Great sturdy frame. Fits the emax magnum micro stack very well. Only issue for those using a stackable 20x20 vtx is it might not fit. Barely fit the vt03 on top angled to sit between the stand offs on top of the fc sitting on double sided tape. The mounting holes could be a few mm closer to the front as the aluminum stand offs on the back end of the frame are extremely close to the esc pads for ones using escs that are positioned front and back.

Great, inexpensive 3" frame. It works perfectly with a Spedix IS100 fly tower stack. The Spedix stack features a 4-in-1 esc with the motor pads going out the sides so they don't rub against the rear stand offs. I used this frame to trans salvaged gear from a dead 3" quad. It was a great and cheap way to get back in the air at minimal cost.

This is for a rebuild from a kingkong 130mm quad, most everything fit, but its very tight since I am adding a HD camera with DVR on this frame build, I had to do some mods. None of the bottom screws holes are the correct size or aligned correctly so I attached my boards using special foam with doubled sided tape on it, it works. I had to borrow pieces from my kingkong drone to make this frame build work also. For a normal build ok, but a bit hard on this HD build with a camera that has a DVR on the camera, plus unless you drill your own holes a 3 stack board system will not work, so its an ok frame.

I liked the shape, but it didn't fit my stack and when I got it, I could tell how cheap the carbon was. I had to take off the rear canopy mounts to get the stack to fit, but it still doesn't really. I don't recommend for stacks with ESCs motor leads facing front to rear. I don't recommend for something with more than 2 board stack

This is a great 3" frame overall. Very durable and at 32g not the heaviest. Looks like a micro Charpu QAV when built. It has a slightly stretched frame geometry. My only compliant is that the 20 x 20 stack mounting holes really need to be moved forward 2mm so that the stack is not so close to the rear aluminum standoffs, possibly causing a short to your 4n1 esc. I use the Emax mini stack so I re-drilled the stack mounting holes to move it forward for clearance. I guess you could use nylon standoffs in the rear but I love the red Alu look. So 4 stars.

Fun

There is not enough vertical clearance to hold my micro receiver and VTX under top plate. Because of design, taller standoffs can’t be used. Motor wires needed to extended from 95mm quad. - The seller did contact me multiple times to try and resolve, and offered a nice discount for the trouble. This frame was not suitable for my 2" prop quad needs, but seemed to be a nice product. I will certainly consider their products in the future.