Artillery Extruder Full Metal Extruder Assembled with Hardened Steel Nozzle on higher temperature resistance up to 300℃ heated, Suitable for Sidewinder SW-X2/Genius Pro 3D Printers

Plugged right in

Easy Replacement

For the price this is exceptional where itsawhole unit with fans, touch, hotend, brackets and even looks great. I had some of these before and performed excellent. This is a base model and will out perform anything that is a stock hotend. This won't be an easy install for me because it going on a printer not ment to have it and would be considered an upgrade for it. These normally print really well too. The thing I don't like about any printer is a ribbon cable must be used and makes it harder to get things to work. Still it's worth it.

Artillery Sidewinder X2 is easily my fave 3D printer. This part makes getting it back up and running very simple. Kind of pricey, but convenience is worth it.Parts can be separated if you don't need the whole assembly. Probably just easier to buy this than individual parts.

This is a replacement Sidewinder hotend modal that makes replacing the original unit a breeze. I wanted to have two, so, if there is an issue, I can swap this one in to allow me to continue printing and take my time to repair the original, or to modify the original to a different hotend without causing me to be down while changing things and to allow me to print any parts I might need for an on going mod.It is nice to have a spare. This is my primary reason to getting this one. It is as good as the original modal and well worth a full 5 stars!

Drop in replacement for the Sidewinder X2 hotend. Its 100% assembled and even thoroughly tightened.All you need to do is attach it to your gantry using your existing screws, and then just plug in the ribbon cable.This hotend comes with all components already installed, like thermistor, heat sock, heater, nozzle, even the leveling probe. Literally everything already put together and good to go.So far its working great.

I bought two extruders to replace my worn out Genius extruder. Good thing I bought two, because one unit had a bad ABL / BL Touch. I have to share the ABL between the two extruders. I tried to contact the seller, but received no response from them. I should have bought three, to get two fully working units. Otherwise, they seem like good products and you can't buy the parts alone for this low price.

This piece is well made. I took it apart to make sure it was assembled well. It was. Everything was tight and connected without any stripped screws or any gaps. It came with covers and fans. The connection port for the ribbon is on the side and is easy to open and insert. I had to get this as a backup part for mine now. I will follow up after it is used.