Ediors® 120w 4 HID Bulbs Hide-a-Way Emergency Hazard Warning Strobe Lights

I installed these in the headlights and taillights in my 2015 Tahoe. I'm a funeral director and needed strobes to run when I'm leading a funeral procession. I installed these and they look and work great. They didn't come with instructions but there are great videos on YouTube that show how to DYI. They are bright and they come with 8 lights but I only used 4. It's great that you can unplug the lights you don't use it has many different settings to change the way the lights flash.

The product is awesome, the different modes are nice. Unfortunately it last me about 3 hours of intermittent use and shorted itself out internally. It’s been 2 months so they won’t accept an exchange. Pretty disappointed because these were a fun addition to my car but a nice waste of $65.

Works just like the big boy brands! Easy to wire up and the strobes are very bright and seem to be high quality. Only con is i ordered the 8 strobe set and had to install 6 ans use the other two wires to get to the back of my 02 f150 supercrew. Could use alittle longer wires for the back.

Installation was simple. Installed in a 2014 Dodge Ram 1500 with a 6 foot bed and had plenty of wire to reach all mounting locations. Installed control module under rear seat and switch on dash. The only thing I had to do was extend the power lead and ran it to the battery with heavier guage wire and I had to extend the wire that ran from the power switch to the control module. The wires could have been longer. I also had two light bulbs that were faulty. I believe they have bad connections on the bulb side. One I can get working if I push on the back of it and leave pressure on it and the other Has a mind of its own. I can not figure out how to get it working consistently. I have contacted the seller about replacement of these bulbs and I will update once I find out how they are at resolving issues. Other than those small issues, the set itself is well worth the money and I would recommend it for your project.

The 2 other reviews are useless.My ride: 2004 TL 6MTThis kit is probably made in China, but so far all 4 strobes are working. I've installed them on the lower part of rear bumper (x2 on each side), tied them up with the back-up light. Many pedestrians at parking lots are not paying attention and the last thing you want to do when driving is hit someone. So, I installed them as a warning to others & my safety.I chose neon tubes over LEDs, because I like the particular flashing characteristics of the neon tubes. I've installed the control unit behind the L/H side of the trunk liner and the switch unit on the trunk lid (had to cut a square opening for access). The neon tubes are poorly made, each one installed on the base at an angle so I had to carefully force them straight. As water protection I applied silicone sealant on the inside of the rear bumper (could not cover the circumference fully) and Airbus A320's tail nav light lens on the outside with 3M's double-sided tape & silicone sealant. Note, that it is rated at 120W so the OEM back-up lights flicker in sync with the strobes, if you go the same route as I did, in which case a relay may be necessary.Not sure how long they would last, but hopefully they last a long time.UPDATE (10/27/16 EST): The neon bulbs, if treated with clear silicone sealant, is really waterproof. My lens collected rain water and the bulb was fully immersed. It still works. The disappointment feature is that even though there are about 4 modes of flashing, the pattern goes back to deafult every time you turn off your car.

The product is great. Quick, easy and straight forward install. The only thing I could say that would help would be the addition of some sort of a users manual explaining which patterns do what and activate which bulbs. It was trial and error trying to figure out which leads were "front" or "rear" and which would flash simultaneously, alternating etc. But I would highly recommend this product and seller and absolutely do it again!!!

The media could not be loaded.  Easy to install, bright and effective! Works perfectly! Easily wired to a switch box for I cab operation.

The fuse inside the cigarette lighter that comes with the lights is 5amps. Once I tested it all, it overheated and melted the plastic housing. I contacted seller to ask them if an 8amp fuse would rid the overheating. They told me they don’t know and to ask someone with more knowledge. So I asked them for the manufacture so I can ask them directly. Seller tells me they don’t give that information out?? How stupid.