Black 40x40x1mm Horizontal Cut

I put 8 of these on my DC DC battery charger in my camper van. Keeping the charger several degrees cooler than it was before. The adhesive bottoms work well. Seems like good value for the money. The small size also makes them versatile.

Just the right size for SanDisk Extreme Pro: 2 on one side, and 2 on the other. Only working with them on one side for now though. Helps keep drive running cooler.

I used these on the power pack for my laptop. I noticed it gets extremely hot. I added 1 heatsink to each side and the temperature difference was remarkable. It was actually cool to the touch.

Used these on a grow light to help keep it cooler. It didn't get hot enough to burn you if you accidentally touched it or anything, but I figured, why not? Gives me a little more piece of mind leaving them on all day when im at work. Definitely drops the temps and looks neat, and adhesive sticks very well.

Does what it should do, works well.

Exactly as expected

A great addition to any electronic device such as audio to increase heat sink surface area and enhance passive cooling or incorporate into an active cooling system. Strong adhesive. Place carefully as you will only have one shot at mounting it! Quite difficult to remove and there’s also the risk of damage to your device should you try to.

Worked great to cool down some 2.5" USB drives I had. Got out the dremel and cut holes in the plastic casings and popped on a heat sink to the top and bottom of the drive and dropped the temps a lot.

I was doubting they were going to work when I bought them, but I was dead wrong these work unreal the Y axis stepper motor was sitting at 51 degrees C and it dropped their temp down to 30 degrees C great purchase would definitely buy again

Habe mir die Kühlkörper für den Extruder meines Prusa i3 MK3s besorgt, da der Stepper-Motor gerade bei längeren Drucken schon gehörig warm wird. Ich war mir nicht sicher, ob die Wärme-Abfuhr ausreichend ist, da hauptsächlich aktive Kühllösungen mit Lüfter empfohlen werden. Aber: Es funktioniert einwandfrei, mit den Kühlkörpern wird der Stepper nur noch handwarm. Die Anbringung ist denkbar einfach, Motorgehäuse mit IPA säubern/entfetten, Kühlkörper aufkleben (Klebepads sind bereits angebracht), fertig.

Del kit di 4, ne ho attaccati 2 (uno per lato) ad un'elettrovalvola per CO2 per l'acquario che normalmente quasi ustionava quando accesa. Risultato ottimo, temperatura dell'elettrovalvola abbassata veramente tanto, con buone speranze per un'aumentata durata nel tempo.

I fitted these to the base of my ATEM Mini Pro. It was getting very hot. It now runs just with a slight warmth. Easy to fit, I used two packs and it will probably get me many more trouble free years out of the equipment.

Para enfriar unos motores