New 2700 psi Pressure Washer Pump Replaces AR RMW2.2G24

low quality, seemed to be a refurbished unit. Pump blew up 15 mins after I installed it, and one of the mounting legs broke, while in use! DONE!

Purchased this pump because brass fittings and cold weather thermostatically controlled release valve to hopefully prevent pump damageI have TroyBilt pressure washer, didnot fit properly but had to shim the pump with washers to keep from hitting washer, also will have to remove pump to change oil as the oil plug is covered over by pump assembly. Not a real big deal but worth mentioning to other potential buyers of this complete pump assembly. So far so good, wife used it to wash down our composite deck

Updating my home power washer. Old one had lost some of its power.

The housing the bolts go through was thinner than OEM so needed shims to keep the shaft from bottoming out and getting pinched so it wouldn’t turn. Once this was done the product work good.

The pump works well but was not an exact fit for my pressure washer. Please not that you will need to shim the pump with 2 or 3 washers at each bolt. If you don't you will break one of the legs off when tightening the bolts.

had old craftsmen outdated no parts. pump lined up good. had to get a different shaft key the one that it came with did not fit pump or motor. the pump is made for motors with out oil drain plug. I use spacers. pump works grate. found if motor ran at top rpm pump motor staled . lower rpms have had no problems

Didn't fit down on the shaft all the way, broke one of the legs off because it had a bit of a stand off. Tried it with just the two bolts. Started and ran fine but when you hit the pressure switch it just stops. Bummer.

Sits about 1/2" further out from engine than original - but it does the job! Very quick shipping, thanks!