SanusSFC22-B1 Steel Series 22" Speaker Stand for Center Channel Speakers Black

This stand is ideal for my large GoldenEar center channel. The height is perfect with the speaker and luckily I was able to setup my center PRIOR to mounting my 85" display so I could do measurements. I like the cable management - simple but effective. The finish seems rugged and when the speaker is mounted, the stand is just difficult enough to move, I am not concerned that it will topple over when vacuuming etc. The instructions however are (as many others commented) are a little difficult to follow - just go real slow and don't tighten everything until you are sure the parts are exactly where they should be. Overall HIGHLY RECOMMENDED by this home theater audiophile!

Easy to assemble. I filled the tubes with sand to give it a bit more weight. It comes with rubber pads for the speaker and height adjustment screws so you can angle the center channel up to the listening position. It also has carpet spikes which keep it very stable. The picture shows a Zaph ZDT 3.5 center channel (32” wide x 9” tall x 12” deep) that I built almost 10 years ago. It weighs close to 30lbs and this stand has no problems keeping it stable, even with a Great Dane bumping it occasionally!

This is a solid stand. Very well built. I'd give it 5 stars except that the assembly instructions left something to be desired. It was able to read and re-read them and finally got it right.

I actually purchased 2 of these for my right and left background speakers; turning them 90 degrees to match the footprint of my Yamaha NS-6490 bookshelf speakers. The stands are pricey, but solid, heavy, sturdy and easy to assemble. Filling the 2 posts with sand would be a bit tedious through the small screw holes, but I found the stands to be sufficiently heavy without that. I also used some 1/8-inch thick rubber isolation padding on top of the stands and under the speakers, as the hardware and rubber isolation supports included with the stands didn't match any holes on the bottom of my speakers. They look smart and unobtrusive. I am happy with my purchase and recommend this product.

We received the wrong product in the first shipment so got from another source. No big deal. Needed something with a larger top plate to hold our Klipsch RP-160m bookshelf speakers. (speaker still hangs off both sides by .5 inches or so)I know these are for center channels but the additional real estate on the top made me feel more confident about sitting these wonderful speakers on them. I may fill them with sand at some point to get rid of the small amount of "wobbling" that is there. They are heavy duty and easy to put together.

Just what I needed! Replaced a small center channel speaker that was wall mounted with a larger center channel speaker that I had from another system. This stand worked out perfectly to hold the speaker under my screen in my Home Theater. Solid, simple design that is heavy duty.Attached picture.

Heavy duty, everything was threaded well. Just get prepared to completely wing it on the instructions. Doesn’t take long, just have to figure it out yourself.

I first bought the 18” version but it didn’t workout great for my needs. The base was a little too big to fit where I needed it to go, and the stand itself was also a little short. I had to use some rubber feet to prop it up evenly bc the base hung over the little step I placed it on. So I ordered the 22” and combined it with the 18” to make a stand that works for me. I used the top plate from the 22” version as the base plate, attached the 22” legs and re-used the top plate from the 18” version. Threw on the spikes to the base which fit fine even though it’s technically the top plate, and filled the legs with some sand. It’s now perfect for my setup. So while I would have preferred to find a single stand that worked for me I’m very happy with the end result. Double the money but still not bad. Figured I’d share just in case someone ends up in a similar situation.