5pcs Amber LED Cab Roof Top Marker Running Lights Compatible With Truck SUV 4x4 (Black Smoked Lens Lamps)

I've had these on my truck for about 2 years now and have had no issues. Easy install and easy wiring. They look good and are as bright as you would want clearance lights to be

This is a 2 month update they still look great , easy to install as long as u take your time and make sure to silicone them also to avoid any chance of a leak . Look and work great.

Very nice lights I have them on my truck and they are very bright and easy to install.

They look really good but they were not wired. last time I purchased cab lights they were prewired and ready to plug. I had to wire them. they should be noted on description.

They last about a year then start to get weathered very bad. They crack and start to leak with LEDs going out.

These a very bright even though the lenses are smoked, look awesome and well made. If they had included a template, it would have been very helpful. These have a straight base and aren't curved to the contour of the truck cab, but theres a nice cushion under the base to bring it pretty close after tightening them. So far, it's been a weak and, after a couple of good rain storms, no leaks. I highly recommend.

This is my second set of cab lights for my suburban. The first set lasted 4 years until some of the LED’s started to go out. I order a new set and they are great just like the first set! I will be ordering more!

This is easy installation instructions to follow and the black look along with the LED gives off an excellent look on the cab. The add even showed how truck would appear and it shows. Definitely recommend this product and would buy again

Like the look Easy install Leaked a bit so I lightly siliconed the gasket and screws. My old OEM ones also leaked intill I did the same thing.

Really satisfied with the product, shipped less than 5 days and everything came accordingly which was good, the only bad part is that the product gave me measurements and pictures of an SUV roof, Nobody has cab lights on SUV’s lol so that made no sense, so I had to transfer the measurements because my roof is like 2 inches shorter in width but for my 2014 Silverado 1500 these are the measurements I took starting at the trim on each side of the roof according to where I wanted my lights to sit. (Be sure to caulk your holes with clear exterior caulking) START 8&1/8” Per Side Height going up from the windshield Throw the tape measure across the roof OVER 4&11/16” Following 11&3/4” Following 9&1/4” Should be centre above your rear view mirror Start at the opposite end and measure over 4&11/16” Following 11&3/4” PLATE MEASUREMENT 8” Full Bottom LED Plate 11/16” Hole top and bottom of LED 4” In-between each hole Now if your wondering “Hm, those lights wont work on a non-HD pickup” But thats where I got somebody to run the wires all the way down to the same wiring harness as the headlights with the control knobs and connect it all, Im not good at wiring so I got somebody good to do it for me. For Non-HD pickups, if you’re looking for a wiring harness you do not have one under your centre console on your interior roof but you can either do what I did or pop the passenger side control box off and figure out your own wiring harness. Hope this helps folks! :)

* SCAM * First of all Don’t trust their “model compatibility “ got the product in the mail and didn’t fit, contacted seller and they refused a refund. Nothing but a waste of money you n my part. And a money grab on their end.

They look really good on my truck. Easy to install.

Wrong lights came in not happy