Hydraulic Front Engine Mount Kit Left with Sensor Wire 2 Pcs Compatible with 2009-2015 Audi A4 A5 Quattro Q5 L4 2.0L V6 3.0L or 3.2L Front Motor Mount Set

They all felt solid in construction and fit great as replacements. Replacement and installation wasn't necessarily easy, but that's because you're replacing motor mounts... not a fault of the product. I knew I needed at least one, and so I decided I would do them all. Glad I did as 2 of them were completely shot and falling apart. Side by side these parts looked almost identical to the original and were completely compatible. Photo and video show just how shot 2 of my old ones were compared to the new. Glad I took care of these before things got worse.

Fit great in the 06 torrent with the 3.4 i think. AWD. Seemed pretty decent. I dont recall which but one of em fought me considerably. I think it was the front one closest the bumper. The old one came out quite easy so i grabbed that and realized it came out easy because it was that worn out. I fooled with it a bit, jacking here, pushing there, and it finally went in. I got this set for less than the cost of the single one i actually needed at the part store. Had em in there a while and still doing what they were hired to do and i dont drive this thing easy. It used to be the flagship of the fleet but it left the wife stranded a while back and has since hit me with some of the most interesting and unique issues. The wife has since taken my truck, i assuming so she can not wax that either, and left me with this science fair project for when it rains and my jeep when it doesent. Ill keep her going until it gets too costly or it blows up but otherwise, good mounts. Id buy again.

Fit like they should. 2011 impala.

Very good products

Fits my 2013 Audi Q5 Right hand drive. No problems, drives good.

Advertise as fitting my car, but did not fit my car.

Perfect replacement works great

I purchased the four-piece set, which is comprised of a Front and Rear Motor Mount and a Transmission Mount and an upper Torque Brace (which the seller refers to as a mount--no problem on what the piece is called) for my 2007 Buick Lucerne, with the 3.8L engine. BUT, the Torque Brace is certainly NOT well painted. In fact, the Torque Brace has what appears to be surface rust that has been painted over. It, (the Brace) is certainly not cleanly "powder coated." My engine bay of my car is pristine clean, and I thought that ordering a freshly-painted Torque Brace would replace an aging Torque Brace with a new and clean one. I'm considering returning the Torque Brace, although the other three "Mounts" seem well constructed and even painted very well. This Torque Brace appearance, complete with uneven welds, will certainly not be installed on my car and I think the seller should replace it.