RuggedTec Adjustable Bicycle Rear Mount 18mm Kickstand 24" - 29" for Mountain Bike/Road Bike/BMX/MTB

Waste of money eyelids are to close needs to drill a new hole I just took the lower half and used it on the one I needed replaced and it worked

Good kickstand, but for some reason it doesn't exactly fit my Giant Sedona DX like I expected. There are two screws used to secure it to the frame, but they both frequently need to be re-tightened and the lengths of the screws are either too short or too long. I know this kickstand was not made uniquely for this bike, so I can overlook this issue. I bought the bike, and later the kickstand, at the height of the pandemic and bike shortage, so I was limited on what I could purchase. After several rides I just tighten the screws down and continue on.

Looks factory on the bike. Have a friend with the same bike and he has the oem giant brand on his and this looks way better and seems much tougher. It fits the standard mount flawlessly.

Using this on Trek 160mm travel e-bike. Originally had the Trek kickstand but the angle was off, this is straighter so bike does not lean as much. The screws do loosen up over time so I reset screws with red loctite

This kickstand was a perfect fit for my Trek Roscoe 7 mountain bike. It was very easy to install using the provided screws and I set it to the maximum height. It is a bit pricey for a kickstand but works great.

It’s solid and looks good but if you do downhill will hear some noise

kickstand has a compression coupling in the middle, holding upper half to lower half. This compression fitting became loose. silly me i just pushed it back together. next time i checked the the bottom half of kickstand was gone. seems like coupling lacks an internal ridge or stop or strong detent, which would hold it in place.

This is a well-made kickstand with a very sturdy spring. Easily attached when mounting to bicycles with the bracket already attached as a part of the bicycle frame.