U-MAX 10' x 10' Shed Outdoor Storage Shed Clearance, Metal Garden Large Yard Steel Shed with Design of Lockable Doors, Tool and Utility Storage for Backyard, Garden, Patio, Outside use

Shed is Hard to put together. I have put many sheds together. This one is spot on however, every single screw hole is perfectly aligned. Very unusual, normally you have to drill 5 to 10 new holes as they just don't match up. Screws and bolts are just too small. They do this so no one gets a poke from a screw or bolt when entering the shed after installation which would result in buffoons' having a law suit. Engineering is spot on, but still very difficult to install, Takes 2 people, and I cant stress enough to watch the videos several times b-4 assembly. When assembled is a sturdy good looking shed. Pour a slab to mount it on and use 4 tap cons and washers to affix to pad. Protective plastic covering is EXTREMELY difficult, I took a razor knife and ran it down the edges of the panels to be able to remove the plastic, Good Luck,,,,, Buy it, it is Worth The Work! It is a lot of Work however!!!!

It really needs 2 people to put the shed together as the walls are flimsy. I tried to do the whole thing myself but needed a little help when connecting the walls. Overall, it's together, in place, and filled with garden stuff. Wind and rain are no problem, I've never had an issue.

This was a perfect little shed. I was debating between this and a much more expensive resin one. I decided the difference of about $500 wasn't worth it. I made the right choice. I read many reviews and the questions I had after reading them were answered. 1. The color was a nice tan/gray color. Not the chocolate darker brown it appeared in some pictures. 2. Assembly was not super easy, but not horrible either. You absolutely need 2 people unless you are Stretch Armstrong. Nimble fingers for small screws and an electric screwdriver are helpful. 3. It took longer to peel the plastic off the pieces than it did to actually assemble it. It was shrink wrap meets packing tape. I prepped the shed 1 day, assembled the next. I highly recommend this. Your fingers will be hurting from peeling. 3. After assembly, there were a few gaps, so I used Great Stuff, aluminum tape, and 2 stick on door sweeps. (For the hinge side of the door. Want to keep the bees out. Hopefully this works. 4. All but the LAST hole lined up. 5. I purchased tgin threaded 1 foot rods @lowes and bent them into U shaped to sort of anchor them to the ground. But a pea gravel base thick enough to lay on top of the base frame will work. 6. It survived some outer rain bans of Henri, but we didn't get the strong winds. The rocks on the floor were wet, but about 3" of rain in like 2 hours may be the reason. It was raining buckets for about 45 min. The shelves in the pic show no evidence of being wet. 7. I noticed a spot of rust starting where the side walls meet the roof. That is a little concerning since it hasn't been up for a month.

DO NOT PURCHASE THIS SHED!!! This product is terrible. There’s no other way I can describe it. Each part is extremely difficult to find, most are labeled incorrectly, if you can actually find the correct pieces that go together based off of the “instructions”, they still don’t really fit. Worst of all, the instructions for assembly are an absolute joke. They are unequivocally, the most terrible, hard to follow, and often times just incorrect instructions I’ve ever seen. Once I finally figured out that I had a few incorrect parts, I reached out to the seller and after multiple messages back and forth with various “customer service representatives” they mailed me the missing parts, which arrived WEEKS late. So I had half a shed up in my backyard that entire time. (Side note: when asking for a partial refund given the situation, the “customer service representative” I was working with offered me a whopping TEN dollars back… what a joke. More on the assembly being a utter disaster, towards the end of the assembly process everything was so impossible to follow that I finally just had to go to another store and buy 20-30 different screws to add them around the roof just to make this thing function like a shed. I cannot stress enough how much of a pain/disaster not only this entire process has been, but the actual product itself is as well. If I could go back in time before owning this giant pile of garbage, I would tell myself PLEASE pay the extra money, and get something much much better.

It’s a great value and size (5x3) that isn’t very common and just what I needed but that comes with a caveat, it’s a tedious setup. If you’re not mechanically inclined, don’t have tools and somebody to help I’d buy something else. I managed to do it myself but it took much longer because I had to prop up pieces as I went using a variety of creative methods. The reason for 3 stars is the packaging could be better, had a couple of deforms in pieces but nothing major. First, there’s a protective plastic film on all of the pieces which is nice because it protects it in shipping. The bad part is removing it. It’s on there pretty good so I suggest you leave the parts in the sun to soften it so removal is easier. Be careful of the extremely sharp edges. They include these cotton gloves but they’re useless in my opinion. Wear gloves that have a grip and can stand up to the razor sharp edges. You will definitely need them as you are trying to get the plastic off. Once you manage to get all that off the assembly is next. It’s not hard but you do need to pay close attention to the pictures and pieces to make sure it goes together right. I think a couple people can do it in 3-4 hours, it look me several because I did it solo. It’s a nice sturdy shed when done but you will need to spend your time to get there.

We were looking for a small utility shed to keep some garden tools in, and this one was PERFECT at 5' x 3'. You can see the attached pictures if you're so inclined, but I really wanted to review the assembly since everyone seems to be crying about it. There are reviews saying this took 10+ hours with 2-3 people and the holes didn't line up and all this nonsense. If you have the slightest mechanical inclination, this is about as easy as it gets. Every part is numbered, the diagrams show the assembly with the numbered parts (including numbered hardware) and with the exception of two somewhat ambiguous diagrams, this was a breeze. I did this, by myself, on a windy day, in less than 6 hours. The most time-consuming part was legitimately breaking the plastic washers off and putting the screw through them. If you have a helper, this should take 3-4 hours max. Every hole lined up perfectly. I'm thinking these guys who had to drill their own holes tightened a bunch of bolts before getting the rest of them in. Rookie mistake. Great product for the price. Please disregard the construction demo zone in the pics 😆

This item seemed to get some mixed reviews, but I was confident that many of the bad reviews came from people that are not very mechanically inclined. The directions were fine, just follow them. I enjoyed putting the shed together. Everything went together perfectly. All the holes lined up the way they are supposed to. The designers of this shed are geniuses. The design was so incredible, I was even able to build it with the door on the opposite side from the way the instructions had it, which is the way I really needed it. If something doesn't line up, you are most likely doing something wrong. This shed was perfect for me. I have a 2x3 multi-level storage shelf I wanted to put inside, and it couldn't fit any better. I can actually stand up inside. Way cool! For those people who had problems with bent metal, I would blame your shipper, not Amazon or the manufacturer. Mine was in perfect condition. For those people complaining about price, it's cheap sheet metal. What did you really expect? It's not a Tuff Shed. Maybe you should have bought one of those, so you could really complain about the price, LOL! UPDATE: Sorry, I meant to include this info in my original review. First, my hands are so large and the screws are so small I did manage to drop or lose a few, and there are extras in the contents. A nice addition! At least one person mentioned not to build this on a windy day, and he was very correct. Also I would highly recommend NOT using a cordless screwdriver or drill, as sheet metal is very easy to strip screw holes. Tighten by hand, and not super tight. And I will also probably use the foam sealer myself, as to not allow insects to come inside, as wasps have a tendency to do that kind of thing to sheds. Lastly, as I mentioned earlier, follow the directions. One person alone can easily put this together in under 8 hours, as I did. If you are having trouble keeping the first two opposite walls upright, install one adjacent wall (right angle) to keep it up. Use a little common sense. And one final tidbit: if you have damaged your shed to where the screws are not holding, or maybe the wind has done some minor damage where screws won't tighten, the nice thing about this shed is that you can use pop rivets of the same size/diameter and it should hold just about forever. A much cheaper fix than sending it back or bashing the manufacturer. Is truly a nice shed!

I absolutely love this shed, it arrived in a damaged box, so I was very skeptical at first. Once I put down the base and started putting up the panels, it was way easier than I thought. The bent pieces from shipping straightened out easy and everything was great once put together. I did this by myself on a non windy day and only had issues with the screws on the roof lining up. It was easy if you follow the instructions. It took me a few days to put together after work several evenings as I moved at a slow pace everyday to make sure I did everything the instructions stated. I think in total took me 6 hours by myself. I expected the door to be difficult but was really easy if you follow directions. It looks good and is very sturdy. Were I live in Dallas it gets really windy and I do think it was survive high winds. I added a solar light inside with the solar panel on roof and the wire coming through small hole in the door frame. I am so impressed with this shed.