Yoaoo 3pack OEM Tahoe Red Line Nameplate Emblem Badge Letter 3D Logo Compatible with Suburban Original Redline

I bought this item twice and installed it twice, so I am pretty familiar with it. The letters are glossy and almost the exact same size/shape as the original letters. The paint has slight imperfections, but nothing terrible and very reasonable for $50. The first time I installed these I put them on exactly where the previous adhesive marks were. Turns out they were a bit crooked/off because the adhesive isn't in the exact same spots on the originals and on these. The second time I lined it up with tape like the pictures show, and they came out great. Removing the first set was just as hard as removing the originals, so I would say the adhesive is excellent. The product looks very sharp - WAY better than PlastiDip. My only complaint is that the adhesive tape is gray and it does show a bit when looking at the letters closely... I wish it was black but this is a small thing to complain about so I didn't detract any stars. Overall, highly recommended, but take your time on installation.

Used for 2018 Tahoe same lettering as previous years. Gloss black paint is pretty good and still holding up. The backing is a bit sketchy on the "H" and "A" due to the hollow recess behind the letter, had to use extra 3m adhesive. They are individual peel and stick, as the spacing on the sheet IS NOT the same as on your vehicle. All in all happy with the purchase.

Perfect replacement

my only negative is the letters are crooked on the clear plastic, you peal the protective paper and you use the clear to install and the letters are a little crooked, so if you are very picky you will need to place 1 by 1

No mylar included so make sure to measure your lettering and use a level when installing.

It was simple to install. The hardest part was removing the old ones these were gona replace

Thank you my order came very fast. And it looks just like the picture. Only thing im not sure will they stay in place on my truck. I thought they would have been made different and there plastic well see hiw this works

These look great and very easy to install too.

EMBLEMS ARE AS ADVERTISED!!!Install is not difficult if you have the right tools.Step 1 - Clean your vehicle.Step 2 - Apply tape around the top, bottom and both sides. then place a mark on the tape where each letter starts and stops.Step 3 - Use a heat gun to heat up the emblems and carefully pry the old ones off using a plastic pry tool.Step 4 - Use a rubber adhesive remover wheel attached to a drill to remove any excess adhesive.Step 5 - Clean the Area with alcohol to make sure the surface is clean.Step 6 - Use the heat gun to heat up the adhesive on the new emblems and apply them to the vehicle using the marks on the tape as a reference.Step 7 - Apply a little more heat to the installed emblems and press them on firmly.Step 8- Remove the tape and you are all done.REASONS FOR LOSING A STAR!1. -1 Item description is wrong.2. -1 Slow to ship item.3. -1 Item arrives damaged or defective.4. -1 Poor quality or workmanship.5. -1 Lousy communication.If I leave a 1 star review BUYER BEWARE as a 1 star review is actually a ZERO star review!

Easy to apply and good quality