60"x108" (5FTx9FT) Gloss Red 24K Chopped Forged Carbon Fiber Textured Vinyl Wrap Auto Car Sticker Decal Sticker Film Sheet Bubble Free Air Release Technology with Tool Kit

Very thick. Rips easy. Tried a 60x72 2 times and rips hard when you try to yank it off to re-lay it. Pretty in sunlight

i used a heat gun to make it easier to pull the wrap over the edges of the covers i used this on and the do not stick very well only around the edges, i pulled it around the back side but it still is peeling up probably wouldn’t buy this again i’m sure it won’t last very long considering it’s already peeling and i just put it on today. color looks great it was easy to put on, i guess you could say you’re getting what you pay for.

I've wrapped my fair share of cars so I figured I could manipulate this vinyl well enough to do what I needed it to do. I was way wrong. This stuff will work great for tiny little projects, but if you are going to use it for a whole car I advise you to steer clear from this. -Adhesive is over powered. - the glue will pill off the back of the vinyl. -if it happens to fold into itself, good luck getting it unstuck.

El papel es de muy mala calidad se descolora tan solo de calentarlo para darle forma en alguna vuelta las arrugas no salen permanece a pesar de q le de scape de nuevo el papel no sirve

I ordered a sample of the 24K Chopped Forged Carbon Fiber Titanium Black Vinyl Wrap. Loved the pattern and the color is a perfect color to go along with my build. I did however notice that when I attempted to heat and stretch the film that it would lose the pattern completely and just to a solid gloss color. I reached out to the company and expressed my concerns, and was informed that I shouldn’t use too much heat and to avoid over stretching. Advised to possibly use a hair dryer on low heat. I went ahead and ordered a 5’x20’ roll. I have attempted every way I can conceive to not lose the pattern in the film. I have used a hair dryer on low heat as advised up to the point where you can see the pattern start to disappear. Unfortunately this doesn’t get the vinyl warm enough to wrap to complex shapes. You definitely can not wrap mirrors. If you have any heat whatsoever and attempt to stretch the pattern is immediately compromised. It has absolutely no memory, does not shrink, and although you can slightly stretch it around corners, if you go too far it then just becomes a solid color wrap or snapps. I had to become creative when wrapping the exterior trim pieces on my car, and fortunately the chopped pattern allows for you to overlap and overlay it and hide it. If I needed to shrink it I would instead have to cut and remove material then lay it to where you couldn’t see the cut marks, and if I had a corner or curve that required quite a bit of stretch, I would have to cut and piece in material. Again the pattern helps hide these imperfections. I think this is a really great looking wrap however it definitely can not be compared to higher quality brands such as Vvivid, 3M, Tinybot etc. Hopefully they can figure out how to provide this style that allows you to stretch and shrink the material without the fear of losing the pattern.