JunFac 51033 2.2 Wheel Widener (4) (Offset: +19mm)

I bought these to get a bit wider stance on a 1/18th ECX Temper crawler.They work really well. They were easy to install, seem well made, and did exactly what I needed them to do. I did have to drill out the center of the wheels a tiny bit in order to get them to fit, but that was easy enough to do.Overall I highly recommend them.

The spacers seem like high quality, only problem i had was fitting the nut into the wheel since it was too big which meant I had to make the hole in my wheel a bit bigger to fit the nut, but other than that, the spacers are great, just wasn't really sure what to do with the spacers and if I installed it correctly.

The Axial Yeti uses special adapters in the rear to make the track width match the front. Using aftermarket wheels will make the rear track narrower than the front unless spacers such as this are used. This product easily withstands all the abuse I put my Yeti through. Only mod I had to do was drill out my wheels to let these nuts through but most decent wheels should already have the correct bore.

I have the smaller spacers & they're fantastic. The ONLY thing about these is that you have to tighten the nuts VERY tight as they tend to come loose. Also, that could be because I'm running plastic rims & not aluminum ones just yet. Either way, this is a solid upgrade & damn near necessity to stop flip overs.

Works exactly as expected. I used them to extend the wheels on my Losi Night Crawler. The tires don't come anywhere near the shocks now and you have to be at full flex with the wheels turned all the way to hit the stock body. fits 12MM hubs wonderfully.

Work good on my vanquish bomber they do come lose and the washers suck but still works!

worked great

Works great on RC SMAX to add bigger tires