Motorcycle Rear Brake Pump Master Cylinder, Hydraulic Pump with Reservoir for Most Motorcycle Dirt Bike ATV

First one lasted 3 years. Then leaked. Cheap enough i bought a replacement. Couldn't rebuild the first one. Repaired it. But seal was worn too much. Still worth the money. Not plug in play. Drilled hole bigger in mount and used washers to shim it. Used on a 1988 cbr1000f

Does not fit 02 Yamaha Kodiac 400 without major modifications of drilling and filing to fit. Inlet is in wrong place for Kodiac outer bracket and holes too small for stock bolts. Was able to make it mount up but dont recommend. That being said the unit seems made well - not junk. Pumps fluid without any leaks.

I used this for my 1999 Kawasaki concororus. I had to drill out the mounting holes for bigger screws and mount the resivuar lower than the original due to the line being shorter. The reservoir is pretty small but it works. You can tell the product is cheap when handling it but I've been using it a month now with no issues.

needed to make the holes bigger

Would buy again

Don’t fit

It did not fit as described

It works perfectly. I use DOT 5 silicone based fluid and no problems. Replaced a NLA rear master cylinder on my 79 KZ1300A1. This was a custom install with new mounting holes drilled in the bike bracket to match the new MC.

Fits my Arctic Cat 500. Just added a turn buckle to add length to rod

La recomiendo si funciona perfectamente

I installed the master cylinder on my 2007 Arctic Cat 700 EFI.Was able to switch out the push rod with mine to make it fit, just had to file the washer a very little bit.Took a little bit to bleed the caliper, that may be because I didn't put the reservoir cap on right away.Overall, I would recommend this part, as the price was right as well

Good quality part , used for restauration

Worked perfectly on my homemade go-kart. Found it easy to bleed with the remote reservoir.