Duda Energy Sheets:25u 1 yd. x 72" Singed Polyester Felt Filter Media Fabric Sheet, 25 Micron, Polyester

This is a rather thick, polyester felt filter, and I bought 5-micron pore size. With plain tap water, the water flows through without significant slowing by gravity alone.I cut this filter in a circular shape of 64mm diameter and used with Aeropress coffee press. I used very fine ground bean thoroughly mixed with hot water for 90 seconds and poured into the Aeropress for filtration. Sure enough, the coffee ground clogs the filter just enough to minimize the "wash through" or water that flows straight down without contacting the coffee ground much, to a pace of a very slow dripping. With the pressure, the filtration becomes faster, as expected.In more normal operation, I wet the filter with hot water, place very fine gound coffee on the filter, pour just enough fresh boiling water to wet the beans and stir on the filter. The filter is robust enough to take the mechanical stirring with a spoon, unlike paper filter. Then pour more hot water to make the final desired volume (in my case 20x the bean weight), stir for 90 seconds and press the coffee out.The cup quality is closest to cotton flannel filter, commonly used during the 1930s and 1940s. This 5-micron felt filter may allow a tiny bit of fine coffee particles that cotton filter would have removed cleanly (very fine grind will prevent this, as the particles will clog the filter surface and effectively prevent any other fines from flowing through). The cup quality is comparable to what I get with a cotton flannel filter and significantly better than with a paper filter. In comparison to Disk Fine filter (very fine pore stainless steel filter) this felt filter allows much less solid coffee particles in the cup. You can drink to the last drop without unpleasantness.The filter is a bit too thick to fit in Aeropress, unmodified, but with firm pressure, you can place the filter assembly together.After use, and with a wash in plain water, the filter has residue of visible but slight coffee stain inside/within the felt. This accumulates over several uses. This seems some organic compounds that are in the coffee but adsorbed on the filter fibers and cannot be easily desorbed and washed out. I found this stain rather easily washed out by carefully boiling in a stainless steel pot, with a little bit of OxyClean (be cautious of splashes and use protection). The oxidizing bleach chemically decomposes the adsorbed compounds and get them to desorb and wash out. Even after hard boiling in the harsh OxyClean bath, the filter was dimensionally stable and didn't shrink. No smell left, either.I find it convenient to cut out several of these filter discs out of a felt and accumulate used filters after a few uses, with a good rinse in between. Then I boil them in a batch.For Aeropress use, if the filter were half the thickness, it would have been perfect. This polyester felt filter is added to my very short list of favorite coffee filter material, with the other being cotton flannel.

I "harvest" rainwater for cooking and drinking. So, it's a strictly small time operation. I go through several stages of filtering so as not to clog the filters. First is through Duda's 25 micron filter (fits over a 5 gal bucket), then through a 1 micron "sock" then this .5 micron flat sheet cut to fit inside the filter that goes over the bucket. Then, filtered through a Lifestraw "Family 1.0", and finally through a standard Brita filter. For straight drinking and cold drinks I take the additional step of boiling.Sounds extensive and time consuming but the first two steps are quick, seconds to minutes. It slows down with this .5 micron filter and the Lifestraw filter in that order. Boiling is of no consequence as I only do a ½ gallon or two a month. Payback comes in a huge improvement in the flavor of any drink or food you can think of that requires water. I now make the best coffee!!Bottom line is this filter is filtering, even after the 1 micron sock!!!

Though most people would use this for aquarium filters, I purchased this to use in my homemade COVID-19 masks. I was searching for a 10 micron fabric but couldn’t get any due to demand. This sandwiched between cotton fabric gives me more piece of mind than the 4 layers of cotton officials suggest. It actually has fairly good breatheability and since it’s primary use is aquarium filters it’s definitely washable. It beats taking apart an HVAC filter and cutting it up plus the HVAC filters rely on its electrostatic properties to reach their micron levels which would wash away if laundered.

Works great for cold brew. Brew the coffee like you normally do cold brew and just run it though a funnel covered with the filter paper. Yes, it will fill up with sediment, just move to a "clean" piece. Doesn't slow you down like the filter bags. And it's much easier to clean; it looks like new in just soap and water (rinse it of course). If you're in a hurry, you can even toss it; the 1 yard by 72" is enough for at least 20 uses even if you only use once. We make Nitro cold brew at work and go through 5 gallons a week. All the brewers love this filter material. It clears the coffee clean enough to give a great long-lasting Nitrogenated head, yet is easy to use. I'm the boss, I love it for those reasons and because it saves time and money.

I use this filter for filtering my beeswax - a must have for any beekeeper or beeswax candle maker. Gets the wax SPOTLESS. I run the dirty wax through some maplesyrup filters before i use this 1 micron sheet. This is the finishing touch. Just cut into circles as the sheet is huge and it’ll last you a while.

I cut it into squares and put it in koi pond skimmer. Helps clean the algae and keeps my pond clear. Good product. You can clean it several times before replacing. It’s similar to a felt like material.

I use these to filter beeswax. Depending on how much is in the wax, it may take 2 maaaaybe 3 times but it gets it clean and is very sturdy

This felt is terrific. I am using it for an inexpensive way to filter a small fish tank with ich. Nothing was working so I researched effects of filtering with small micron and water changes. I cut it to size for the filter and replaced daily for several weeks. 72" x 1 yard is a lot of material. I could make daily filter changes for months with this. I'm glad I don't need to because the ich now appears to be GONE! Something the chemicals didn't seem to accomplish. I will continue to use this and definitely buy more when it starts to run out.