DC Sports Polished Stainless Universal Bolt On Exhaust Tip 2.25" Inlet / 3.75" Outlet / Slant-Cut | EX-1012

Sounds great! It looks awesome on my golf. I had a secondary cat and muffler delete done so I purchased this to go over the little straight pipe that the welder put on, I just used the clamps to install it and I love it. It gives the car a nice little deeper rumble than it already had.

Why did you pick this product vs others?:Easy install. As others have stated, bolts can stick out but it depends how low your exhaust sits for it to be noticeable. Using on a rav4.

Heads up folks! If you are buying this for a 2nd gen Tacoma please note a few things. One, don't expect this to change the sound of your exhaust, it does not...strictly a visual enhancement. Two, and most importantly, it will NOT fit your tailpipe with the provided hardware. Simply toss those little brackets. Next, what I did, is tek self tapping screws (3) into the tailpipe. It ain't going anywhere and looks fantastic.

Well DC needs to have what size exhaust it will fit on just states will fit most trucks. Didn't fit my Frontier it has a 3 inch exhaust so cant install! Overall good quality exhaust tip, nice finish will use on another vehicle.

Good value for the money. Good quality, easy installation and sounds well.

First off, let's get this out of the way.... In spite of other reviews I've read, this really isn't going to change your exhaust note any. It's mainly a decorative tip. For that aspect, it looks nice and installs easily enough if you already have a large exhaust pipe coming out of your muffler or cat-back system.I say a large pipe because the small adjustment bolts start to lose a little of their holding ability on smaller pipes. If you use this on a 1.75" OD pipe like I did, it WILL rattle. For bigger pipes, like a 2.25" OD, it should hold better. I ended up swapping this for a tighter fitting tip made by Vibrant Performance.

The media could not be loaded. Fits a tad bit tight for 2008-2012 Honda accordYou only need one adjustment screw so make sure it’s super tight.If you try to use all three. It’ll not fitLooks much cooler than oem, oem is some weird oval shape I prefer this.It sticks out a little too much but it’s fine

Bought this to upgrade the tailpipe look and it absolutely did it. Black coating looks high quality and the shape and fit make this look factory race on the car. I measured carefully and cut about 4” off the tailpipe with my sawsall to get it mounted where I wanted it. Be prepared to trial fit and make it centered on your tailpipe. Also, since it’s larger that the stock pipe you may need check clearance of the rear valence. I also hit the end of the cut tailpipe with some black heat paint so you don’t see it if you look directly into the tip.