SM61F Turn Signal Switch with tilt wheel

Worked nicely for my 1979 F100 automatic transmission with tilt steering wheel. I had to carefully draw up and install the connector with a hand written pinout as the wire colors are close but not exact leading to a possible issue. The original automatic transmission bulb wire was used and the light bulb socket pulls straight out for easy replacement of the bulb. Of course you have to take off the steering wheel shaft dash under cover to access the wires.

Wires are diffrent colors but with a little research it works great if u look at the picture attatched is the correct placement of wires in the socket connector thank me later

Got my buddies truck working back to normal

Installed on a 79 Bronco. Repaired my tail light issue. Easy to install and was just like the original

it was perfect except for the electrical connectors,they were to small to fit the originals.after inserting them into plastic connector you can only squeeze them half way together.i used a wire tie to hold them secure. works fine.

This worked perfect for my 1979 Ford F100 Custom with tilt. My oem contacts were shot and only had one good brake light. This switch fixed my problem. Now my truck is back safely on the road again.

Color coded wires are not the same as truck wire harness. I had to reverse engineer the system to get wires hooked up correctly. Not a simple hookup.

perfect fit., solved my problem with brake lights and signals and canceling signal. Works like new again.