DSG ARMS - Alpha Lighted - OWB Kydex Holster - Outside The Waistband - Made in USA - Compatible with: Glock/HK/Sig/M&P/Most Brands

I'll start by saying that these holsters are nicely made especially for something that is mass-produced. The edges are rounded and polished, and the retention of the firearm inside the holster is exactly what you would want. HOWEVER... the curvature of the mold used is so severe that your belt may not pass through the loops easily, if at all.The holster I purchased was for a Glock 19/23/32 with Streamlight TLR-7 light attached. My leather gun belt from Hank's Belts simply won't pass through the loops as there is not enough clearance between the "wings" where the loops mount, and the portion molded for the gun.A lot of manufacturers have switched to an 80/20 mold where only 20% of the gun's width is pressed into the back piece of Kydex and the other 80% is biased toward the front piece of Kydex, to avoid this sort of problem. Unfortunately DSG Arms seems to be using an equal 50/50 distribution between front and back pieces of the holster, which sadly sets up this issue.You might be able to use this holster with an "instructor" style canvas belt as long as one of the buckle ends is removable. There's definitely not enough clearance between the mold for the gun and the belt loops to pass a Cobra buckle or even the smaller end of the Hybrid Cobra buckle through it.Really nice holster, but really bad execution on a very critical piece.

This is a very good looking holster. It appears exactly as pictured. It absolutely would not lock down on my Sig P226. As I was attempting to tighten the holster, I realized the rubber gasket between the front and back was too thick - so I removed it and cut it in half, lengthwise. It still would not let me get the holster tight enough to lock my Sig in place. I have one of these holsters for my Sig P320 and it works just fine. However, this one just wouldn't fit the P226.

This fir the Glock34 with TLR light OK. But was very tight to draw, and was chaving off plastic on the light and part of the slide. I ended up holstering the pistol, then using a hair dryer to loosen up the kydex a bit. Since then it fits perfectly.The finish is well done. The unit works well.

I cc every day, all day long. I favor caring my s&w shield with TLR 6 and there have been few holster choices. i have tried a few, but this one is an excellent choice. It is form fitting, comfortable all day, reliable kydex snap in carry and adjustable. Highly recommend this holster.

Bought for Mr918 which is essentially the glock 19 with tlr-7. Fits very well with no wiggle. Adjustable retention and ride height, so love that. Belt loops are great and in the large side which fits great for those thick leather carry belts. So comfortable I hardly notice it's there. Only issue is there is no affirmative snap into place when holstering. Still good retention, I'm just used to the "snap"

I searched high and low to find a holster that would accommodate both a Trijicon RMR and a weapon mounted light and this one does. This holster is perfect for my M&P Core and Streamlight TLR1. I'm all set for the next low-light match.

Awesome holster, fits tight to the body for concealment. I like the retention screw to adjust the draw.

This holster is extremely durable and lightweight. I carry a full size Springfield 1911 with a TLR1 every day and have had no issues with retention or holster wear. It would be good to note that you should wear a sturdy belt while using this holster or it will move back and forth along your belt line a little.