DakRide 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 Jeep Wrangler JK Door Hinge Step Metal Folding Foot Peg Door Step Pedal (1PC)

Great product! Good quality, great construction, VERY unique design, the install was really really easy. I had no issues with fit or getting them installed at all. My only suggestion....make sure you test each light with your anti-flicker and your decoder connected TO your vehicle before screwing them in just to make sure everything works properly. Mine all worked flawlessly but one of my decoders you could tell the connection wasn't 100%...if you twisted the wire in one direction, it would lose power connection and would flicker so I had to secure it so it wouldn't lose connection while driving it the cord happened to shift.These ARE DOT/SAE.....trust me..they not only say it on each light but we have had torrential rain this past week and the lights are like little submarines...not a single issue with moisture...and I live in the SE of the US...humidity and moisture here are like oxygen in the air......MAKE SURE YOU zip-tie everything down!The blinker light function on the headlights and the daytime halo on the fog lights, make sure you get this: Solderless Wire Quick Splice ConnectorThe blinker function for the Wrangler is ALWAYS going to be the exterior white wire on the blinkers, and for the daytime running lights for the fog you need a constant "on" power source, this is ALWAYS the white middle wire of the blinkers. So you can connect both to your blinkers and use the solderless wire connector to clip in both and there is no mess, no stripping no soldering, no messy tape....just insert, click, connect and go....done.Would recommend these to anyone! They make all the difference in a heightened look for my Wrangler

I installed these lights on my 2007 JK. Tested them by plugging everything in before installing. The plug adapters are garbage. The pins in the plugs came loose and would push out when I tried to push the plug in. And YES I made sure to align the pins. The adapters are just junk. So instead of having to send everything back because of a POS plug I cut the plugs off of my jeep and just soldered the adapters directly, heat shrunk them, and then taped. Plugged everything in one last time before installing: everything worked. Installed them and replaced grill. Was about to back out of the driveway to test drive new lights: one light cuts out. High beams work. Then other light goes out. Now I have no low beams. Shut down everything. Turned back on. One light comes on for a few minutes then goes out. I felt like smashing them out with a hammer. I should have known about buying this garbage made in China. I am returning them and just paying the $500 for the American Made JW Speakers. Don't waste your time with this crap.

There are not any instructions, but if you can't figure it out, you should pay someone to do it. They provide ~ 20 nuts and bolt but only 4 are needed. 3 mounting points use the original fender mount points and bolts. The other 2 points are done best with self tapping bolt (not included). One side fit perfect. The other had to be convinced but nothing a little pressure could correct. I powdercoated mine Kiwi Green with Glow in the dark clearcoat.

A Fantastic pair of LED Bulbs ! Very Easy To Install and VERY-VERY BRIGHT WHITE LIGHT !

Easy install no dark spots one of the best H3 led bulbs I've used very pleased

Great product... Easy installation.

At Ives in 48 hours. Only took me an hour to install them in my driveway with no special tools needed!

Nice and bright. I am using the yellow film over the bulb. Although they are much brighter than the OEM bulb, I wouldn't expect to see much light on the road.