Simer 4075SS-01 3/4 HP Pressure Booster Pump

Very good pump, works really well & definetly makes a huge difference in the water pressure all throughout the house.

So far pump works great. My pressure from my well is 45-65, with this pump it’s 55-95. You can hear it run but it’s not loud or distracting. It’s made in Italy which I prefer. Hopefully I get years of use out of it.

So far works extremely well. Low noise level. Truly excellent pressure. I had to install reducer to get pressure from 100 psi to 60 psi in our mountain home. We have private well and after installing all filters the water pressure was week on second floor. Got cheaper pump and the noise was unbelievable : it sounded like someone would drill into the wall.You need pressure reducer on outflow for sure possibly intake.I purchased adaptor for pex tubing x2, pressure gauge , and pressure reducer.Plugs into 110V recepticle.Easy install for an average handyman.Very satisfied. The plate to fix it to support is rather flimsy and came bend on arrival. Something should be fixed considered that this is not a cheap unit.

The Simer 4075SS-01 boost pump caught my attention because it was compact and the its performance fit my requirements. I chose to install the pump after my water filter system as to protect the pump small debris, and put check valves before and after the pump to keep the flow going in one direction. Doing this also keeps from pump full with water during maintenance work with filter changes, and water softener servicing. What I observed with the water pressure regulated to 40 psi, the pump will maintain a steady output of 80 psi. Noise level is quiet, like a soft humming sound (heard from upstairs), and the pump runs smooth, so it never vibrates at all to warrant using flex lines as other installs have recommended. I think with the check valves I placed accordingly there is a 7-10 second delay before the pump starts up. I have the pump mounted on two L-brackets attached to the wall that keeps the pump 12-inches off the floor, its small size freed up space in my small utility closes. The monitor panel is easy to read, there are no numbered fault codes to decipher, it simply tells you power on, pump on, failure, and reset. The power cord with 3-prong plug makes the Simer boost pump plug & play. Overall I am happy with my purchase. Highly recommended.

It boosted my pressure from 35 to 75psi. Easy install, be sure to put plenty of teflon on the 1” fittings.We put the pump under the house on one end. You can hear the hum of it kicking on from the opposite end of our home. It is noisy.I can’t speak on the build quality since I have only had it in for a week.

This pump worked great initially to increase our house water pressure, and I was really pleased with its performance. However, after 2 years of use, the pump became incredibly loud to the point where we had to disconnect it due to the noise.I contacted Simer customer support, as the product comes with a 3-year warranty. Unfortunately, I was given the runaround and told to contact the seller for a warranty replacement instead. Now, I'm in the process of reaching out to the seller to see if they will assist with a warranty return or exchange.

I’m on a 10 home community well. My initial pressure was 25psi, which made showers pretty unenjoyable. This pump boosted my pressure up to 65 psi and showers are now amazing! I also installed a pressure regulator just in case I get a pressure spike while boosting, I set it to 65 psi. One thing to take note of is must be mounted on a horizontal surface. I initially mounted it vertically on a wall and the pump wouldn’t shut off. I then went to the troubleshooting section of the manual and it said it must be mounted horizontal. Would have been nice if the manual said that in the instructions which I throughly read. You normally go to the troubleshooting section only if you have an issue. Other than that I’m very happy. I will be super happy if I get a lot of years out of it, time will tell.

Does what it advertises, Pretty quiet