4 in x 5 FT - Carbon Fiber FABRIC-2x2 Twill WEAVE-3K - 220g-Black

Sewn both sides, and has a wide 'fringe'. Very fine weave to it, despite the pictures, finer than I expected. I was able to bond it to a backing then cut it... that dust is h*lla fine and I did cut it with diamond dremel under my dust collection system in shop with the paint suit, respirator and goggles along with gloves, as suggested. The white suit wasn't when I was done. Need to embed now into casts and resin fill the top. Strength, I'm not sure of. Look, is very good. I bought twill weave because I needed the detail. This is narrow enough for me to be able to handle well, a wider sheet would be okay if I was laminating and embedding into something like a skateboard deck, but I'm doing jewelry inlays. Will recommend as a fair amount of square inches for cost.

I used this to rebuild a carbon bicycle fork. I cut the fabric down to 1/4" tows and made an epoxy paste. It worked great in that application.I mixed it in with a West System Epoxy boat repair pre measured packet. When cured, it ground down fast and there wasn't any porosity. Just spray primer and spray flat enamel.If you've done great boat repair with grp you'll like this!

My bad for ordering the 4 in wide. Great quality though. Just to thin for my need

Great quality. Would purchase again

Only received one role.

Great value easy as finerglass

Liked the product very much

100% recommend