Hobart 770074 Welding Mig Accessory Nozzle Gel (5-(Pack))

I weld quite a bit...and I am just unorganized enough so that I often find myself without gas for my mig welder, which means that I switch to flux core, which is a bit messier than mig. That mess, that spatter is often times hard to clean up, both on the gun (consumables) and on the welded part. Since using this I have unnaturally clean tips and nozzle but have found that I still need to take the nozzle off just about as often as always but only to clean out the residue from the gel.I have also found that I can take just the smallest bit of this gel and coat (very lightly) a very small area which will then be protected from the spatter of flux core welding. At the rate I am going through this gel it should last a very long time. It's usefulness, low cost and longevity makes this a great product: I have nothing but great things to say about it and find it very easy to recommend.

works really well, does a good job of keeping splatter out of the nozzle, good product for a good price. This is one of the things a lot of people forget to buy or just don't know they should have it. always use a small brush to swipe it inside the nozzle instead of dipping the nozzle in the gel.

Great stuff. Dip your torch nozzle in this gel to keep spatter and debris from attaching itself to your torch tip. Easy to use and effective. Not only helps to maintain your torch but keeps a lot of the spatter off your weld surface, too...especially when welding with flux core wire

Works great as described. It really helps keep splatter from sticking to nozzles and contact tips. It makes them last much longer than they would otherwise. Especially when doing FCAW. I wouldn't be without the stuff after using it.

I am learning to MIG weld, and this stuff makes up for the poor technique of a newbie welder. Arc too long, too short, wrong angle, all resulting in a mess on your tip, even with shielding gas. I dip the nozzle in this Gel before every weld, and it has made it much easier to clean the tips.

If you MIG weld, you need this. Think of it as teflon for your MIG gun, helping to make your consumables last longer by not getting hot metal stuck all around on the inside of the gun tip. You'll know it if you miss a spot inside the nozzle... No smells, or excessive gooey mess... works great, and is easy to apply and use.

This gel really helps keep the spatter from clogging up the tip while welding. I can weld a lot longer without having to stop and clean the tip and cone.

I recently got back into welding after not touching a welder in nearly 10 years and had picked up a small Lincoln 140 mig machine. this nozzle gel does its job keeps the nozzle clean and makes the gun easy to clean after a long day of welding. not much else to say, it just works well