WeldingCity 15-ft Teflon Conduit Liner 194T-011 (0.030"-0.035") for Miller MIGmatic M-series and Hobart H-series H-9/H-10 MIG Welding Guns

Fits the Hobart Handler 175 with the quasi–Miller M15 gun. It's a Miller Gun but the end that goes into the machine is different than Miller. This is the right end for the Hobart application.

Looks like a quality product. Using for a new project, not to replace an old liner.

I needed to weld a part on an aluminum engine block. This worked and saved me from buying a $300 dollar spool gun. Expect a few jams as you dial it in. Keep the tip clean. It jams easy, but I was able to finish the job. It's a good alternative for the occasional user.

Haven't used the product yet But very confident it will work out .

Works great, easy to install. Hobart Handler 140

wire bound up in it was terrible not good

Retrofitted my Hobart Handler 140 with this and now the feed is really smooth and consistent. Comes with extra length that you have to trim on both ends. Use a razor. Feeding it through the gun is a bit tricky. It helps to rotate the gun and hose as it snakes through the last few inches of the gun.

I bought this Welding City 194T-011 Teflon liner to use with .030 aluminum welding wire to make some small repair welds on a couple of aluminum parts. It was a perfect fit for the H10 MIG gun on my Hobart Handler 140. The gun has a 10-foot line and this liner comes in a 15-foot length, so was more than long enough. I trimmed it back to leave 3/4" from the end of the contact tip adapter. The Teflon liner material is self-lubricating and very flexible, even in colder temps. The Hobart .030 aluminum welding wire I used it with fed through it easily without binding, so overall I'm happy with its performance.

Facile à installer.