60pcs Mini Heatsink Kit, Cooler Heat Sink for Cooling VRM Stepper Driver MOSFET VRam Regulators (8.8mmx8.8mmx5mm) Black

I used these on my 2080 ti power delivery and they lowered the temps substantially. I had taken off the stock cooler and installed an aftermarket air cooler. The heatsink glue worked just fine, I let it cure for only about five hours before I got antsy and put the card together for a test. Not bad for the small price. Worked on the vram chips that I installed them on, too, but you need to put two as these are tiny heatsinks. 2080 ti dropped from thermal throttling to 60 on the die, 73 on the memory. These heatsinks fit well on the vrm components you just need to put them on carefully.

These little heatsinks works really well. I decided to watercool my Zotac Mini 1080 GTX TI 11GB because stock cooling isn't really up-to-par. the Kraken g12 provides a fan that directly blows unto the VRM, but I figured, to prolong longevity of the card (since since its OC'ed) to add these things Most GPU failures tend to occur due to VRAM failure. VRAM needs two of these, while it lined up perfectly with the VRM. Use only a spec amount of the thermal silicon glue provided. In this case, LESS is BEST. See picture. Waited for a day to fully cure, and held extremely well. It's also easier to remove if I want to go back to stock. GPU Hot spots were at 60. GPU itself was 84s during full load 3DMark. Kraken g12 + AIO 280mm + these heatsink = idles at 26, and never goes past 50 during extreme VR Gaming OC @ 2060 mHz, 5600 memory

Good little heatsinks with good adhesive.I'm using these on a high pressure air compressor that vibrates a lot. They held up to that. They are installed on the air lines from one stage to another and it did seem to help bring the temp down. Probably going to buy more to do one more line.

Perfect size we use them when we beefing up our crypto mining boxes

Monté estos complementos con un NZXT 12G, en una GTX 1080ti, en dos años las temperaturas de las VRam permanecieron excelentes.Para retirar el compund (pegamento), solo es necesario realizar una palanca con algún destornillador (sin sobreesfuerzo) y es facil de separar y limpiar con alcohol isopropílico.

Reduces case temperature of semiconductors that get a bit too warm. Makes a marginal heat problem acceptable. These are small so don’t expect huge improvements.

This away work good for me. Just the glue takes a long time to dry.

The heatsinks look good, unfortunately the included adhesive is solid in the tube and cannot be used.