Adviace Replacement Parts for Nexgrill - 4 Pack Grill Burners and Heat Plates Shield for Home Depot Nexgrill 4 Burner 720-0830H, 720-0864, 720-0864M Gas Grills

Old burner parts (burner heat plate cover, burner tube) were pretty much gone.These replacement parts fit perfectly, and work great. Easy to install.Trickiest part was getting ignition wire part off the old burner tube, to connect to the new one (old one was pretty rusted, hard to undo screw, but got it without damging the starter wire.Pay attention to where / how the starter wire is connected to the old burner tube, which holes it mounts next to, etc, and how near the starter wire is to the tube (has to be pretty close for the spark to jump the gap, but far enough that it will spark vs just short out).The built in tabs in the grill body that hold the burner heat cover in place had rusted away, so I just put a screw in place of each one to keep the cover centered. (ie: a screw on each side each end of the cover, 4 screws per cover, to hold it in place. Did not have to drill thru cover, I just drilled into the track the cover rests on.Will definitely order again if these ever give out.

It fits my grill perfectly!!

I got these a year ago, they are starting to wear out but we use our grill almost daily, they don’t wear out any faster than the ones from the manufacturer and are less expensive.

Bought these to replace the rusted ones on a grill. The grill itself is still in great condition except these parts have rusted and were falling apart. Great quality and I love the stainless steel look. My grill only has 2 burners so the fact that this set comes with 4 each, now I have back up. Great price too!

Easy to install. My grill was a bit rusty. I didn't realize there were pins holding the burners in place. At first I thought they were screws. Only recommendation would be to include replacement pins with the gas tubes. Otherwise it was easy to install. I can't wait to use my grill again.

Purchased this parts for my grill. Great quality, works well and easy to exchange.

Good news- the heat shields fit perfectly. Bad news- unbeknownst to me, each burner tube is held in place by 2 screws. If your burner tubes are rusted, your screws are in equally bad shape. My screws were all frozen and had to be drilled out. A couple of hours labor. In addition, replacement screws and replacement cotter pins are not provided so you’ll need a trip to the hardware store to get parts to replace these burner tubes. Now that it’s all done, works great but this is definitely not an easy job for a novice.

Had a neighbor getting rid of his grill the only problem was the guts are these interior parts very easy to change. Cut some aluminum for the rust. It was on the bottom interior. Got a brand new grill grill