Brake Bleeder Kit Dual Mode Pressure Brake Bleeder Kit with 7 Metal Master Cylinder Reservoir Adapters

Works well although I just use it to pressurize the master cylinder on my Lexus with the included Toyota/Lexus adapter. I did not want to deal with brake fluid sitting in the container or cleaning the line/hose out after each use. I cannot comment on its ability to push fluid through from the pressure chamber as I am not using it that way. There is an included wrench to make removing the fill cap easier. I found that hand tightening was sufficient to seal; no need to use the wrench to tighten the fill cap.The instructions could be a little better; there wasn’t an explanation for the hanger chain thing for the catch bottle (it goes in between the bottle and the screw on cap). It would have been nice if the hook end for the chain was a clip type almost like a carabiner as the hook can easily come undone when trying to hang off something on the vehicle. There also wasn’t clear instruction on how to insert the tubing into the catch bottle cap, although it was pretty intuitive on how to do this.

GM 2016 Vette master cylinder, adapters works great with a hose based pump that I was about to throw away as it's brake kit adapters were useless. With these adapters, it's now a great tool! Disconnect and adapters are very nice brass fittings. Should last a lifetime.

This is a nice set of brake master cylinder adapter. When I opened the case, all the adapters were all over the place... the bottom foam cut out is nice, but the top side is loose. The fitment is tight on the adapter I used on my vehicle. The disappointment is the adapter is sharp and they didn't bother smoothing the edges and it actually cut into the brake fluid reservoir. I understand that since it's not threaded that they made it so you slide the housing onto the top and twist tight...the gasket is very tight...I might use some fluid next time to make it easy to slide on and off. This is a good set for folks who have multiple vehicle brands or a mechanic.. the cost of two adapter would be about the same as this set so it's a good value.

If you need only one or two of these, it will be worth it to have bought the whole set. They are quality metal and labeled to easily tell them apart.

None of the adapters fit a 2011 manual Suzuki grand vitara.

Buena compra

I haven't had a chance to use every adapter yet, but the few I have used worked great. They sealed nicely and the whole set feels really well made. Having the swivels on the 90 degree adapters is a really nice touch and helps prevent your hoses from getting pinched or kinked. I would like to see them include spare o-rings in the future because they're going to need replacing at some point. Overall though this is a great kit and will see a lot of use in my future.

One of the adapters wasn't machined right so it won't connect, they seem to fit ok and so far no leaks. The build quality and value for the money would have been better had all the parts worked.