SGTKJSJS 60pcs Mini Heatsink Kit, Aluminum Cooler Heat Sink, 8.8mmx8.8mmx5mm, Black, SRP85-05

Stuck these on VRMs when installing a G12 on a GPU. Stuck around 20 of these things on and let them cure for a few hours... they are 'upside down' in the case but not one has dropped off weeks after. Can't speak for the cooling as I don't have a 'before' measurement but the G12/Kraken + these has the card runnig >20 degrees cooler.

Ok shipping is not really their fault.... but it is perfect for what I need.. wife's account but I use it too.For inside of ebike motor controller to give it just that little bit more cooling in the summer.

Only had 59 heat sinks...

Used these on a 1080ti with g12 bracket with water cooling. The included paste has been holding up well in the last few months as well. Great choice over copper if you have a fan to dissipate the heat.

Easy to use but you need to press it on for about a minute and press on flat surface with a fair amount of pressure to get the paste/glue to spread out very thin but 100% coverage. You want a thin film as you want to get the highest thermal transfer of heat. Also it is important to leave alone for a full 24 hours to cure. It does not setup quick so apply enough to just get it to spread out to get 100% coverage press for 1minute and then lay it down flat to cure for 24 hours at room temperature