OFFROADTOWN Flush Mount LED Pods, 2pcs 5'' 78W Driving Light Work Lights Flush LED Light Bar Super Bright Fog Off Road Lights for Truck UTV ATV SUV Boat 4x4 Car

Bright, easy to install, no flickering issues, works submerged, best bang for your buck.

After reading reviews to learn the good and bad about this product I am very happy with the purchase because you can’t best it fir the price and quality ! So far the leds are super bright which also cast out a good 50ft and the overall construction is reasonably good quality. They are sealed but with many complaints of moisture in the background I went ahead and removed the front fact and used silcone/gasket maker to better help the seal all around the lens and gasket border. People have complained about some LEDs not working and I think that is because they wire them straight to the taillight reverse with no fuse or relay so be aware of that and you should be good! Overall the light cosmetically looks amazingly great installed and the functionality is just as good. I give it 5 stars because for the price it comes with great quality. I have over 15 years of mechanical experience and this product is awesome! These lights will not disappoint!

Ive waited almost a year to write this review so I could give an honest opinion and rating. These lights are perfect for in bumper mount to add some extra light to your factory reverse lights. They are a little tricky to install but overall not bad. Just cut the hole slightly small and finish with a file or if you are careful a grinder. They are tough little lights as I was rear-ended and the hardware broke but the light itself remaind intact as did the lense so A+ on build quality. They are water proof but I also added a layer of black silicone around the edge as some other reviewers recommended and have not had any problems. Over all I would recommend them if you are looking for some extra light.

These are great, very bright back up lights. I have them on two vehicles.

The media could not be loaded. Bought these for a headlight application on a 4wheeler. Inspected them and realized they needed some sealant. I just used a high grade clear silicone. Theres internal screws that may come loose so put some on those also. They hold the actual leds to the mother board. Also had to trim them down so tires didn't rub the back of them. Drove around for two days in deep water and they're doing fine. Decently bright but I run them with a white light bar. Shipped fast, wire up easy, decently bright. I'd buy another pair

Ok

I bought a set of these to match the Offroadtown 18” LED light bar I bought. No complaints. They’re mounted at an angle in the Trailworx bumper and do a great job throwing light out at an angle to the sides. In conjunction with the light bar it’s a pretty broad, bright white light pattern. Not excessively bright, I can use em as driving lights(with out the light bar) and no ones flashed lights at me. But that’s may be because my FJ sets a hair lower in the front from lifting without leveling it.All in all, more than happy for the money spent

Haven't had the instance to review the waterproof part yet but everything else has been top notch