Levigo Car Charger Dual 18W USB PD+QC3.0 Fast Charge for Toyota, Type C USB Car Power Socket with LED Voltmeter Display, Compatible with 12/24V Cars(1.2 * 0.9inch)

Nice fit from my 2013 tundra. Needed the newer charger port sooner or later.

It fit exactly in the switch port to the left of my steering wheel of my 2015 Toyota Sienna. A hair couldn't fit between the edges. It has worked flawlessly and was a good price.

Ok so I got this to fit in my 2016 Tacoma just above my gear shift in that are where some select buttons are. I have a manual so I have a slightly different set up in that area but this button is the slightly smaller squared one and not the longer rectangle one. Our vehicle has two different styles. To power this I tapped into the purple wire on the cigarette lighter and then the black wire aka ground just went to a bolt that was touching the bare body under the dash.Here’s one thing I noticed, the led is recessed so much that where you are looking at it from higher up since it is installed lower down, you can’t actually read it since the electronics inside block the view. To see it clearly you would have to have it installed just around eye height. They should have made it so the led is more flush with the outer part of the button. Other than that it appears to work fine. I also wish that the switch body was a solid black and not translucent so that it would match the trim better.

This charger is well-made and it works as advertised. The voltage readout is accurate +/- 0.1vDC. As seen in the attached photo, the display is easy to read up to about a 30° angle, and then anything higher than that the diffused plastic window makes it more difficult to read. That’s not a problem in my truck since the mounting location is reasonably close to the driver.Great product that results in a very clean installation.

This was easy to install and wire for someone with knowledge of car wiring. It looks like the car came from the factory with this.

I have an 04 Scion xB, this unit is slightly smaller length wise and slightly fatter width wise than the blank/opening that my particular Toyota has. I did a little bit of modification to make this fit in the blank opening.Be sure to measure to make sure this is the size you need before ordering, but it works great.

I needed a USB port in my truck that would support the new wireless cell phone charger that I had installed. It turns out that it really needs the higher wattage fast charger USB in order to actually charge my phone. I had installed a similar USB port several years back that is the same form factor, but it's not a high enough wattage output. This plug is the perfect fix for my issue since it will simply fit right on the same hole in the dash as the one I am using and connect to the same wires in the car. Having the matching form factor just makes this upgrade so much faster and easier.