STAR BRITE Mold & Mildew Stain Remover – Lifts Dirt & Removes Mildew Stains on Contact, White, 32 oz. (085632)

This summer we opened our tent camper to find the roof leaked over spring. I was devastated. I was absolutely sure it would be a huge cost. It wasn’t covered by insurance since it was a faulty seal and I thought we were going to have to spend $4k+ to get the tent portion replaced. The lady at the RV place recommended trying a mold stain removal product first. I had no confidence that it would work, even so I purchased this stuff and gave it a try. The directions said it may have to be applied twice and sure enough I had to do just that. The “before” pics above were taken after the first application (it didn’t occur to me to take real before pics, because I didn’t expect such amazing results, but it was so much worse than the pics). The “after” pics were taken after the second application, the mold stains are gone and it looks almost new! I’m so grateful to have found this product!!!

I bought this to try to restore the seats on my boat that had discolored badly after sitting for months out in the elements. I expected to spend hours scrubbing with little expectation of success. This product worked like a miracle! Sprayed it on and waited about 30 seconds to a minute, went back and was able to basically wipe it all off with barely any force at all. Incredible! Could actually see the dirt, grime, mold and mildew start to dissolve soon after spaying it on. Will definitely buy more of this product for future boating seasons!

The dark mildew discoloration on the underside of my boat cover is gone. No scrubbing, just spray it on, wait 10-15 mins and hose the areas off. Looks like new now!

Very easy to use, on heavy mildew, you might need to use a second application, well known manufacturer in the marine and boat industry

This product cleaned the mildew off of our pontoon seats without the seemingly endless, time consuming scrubbing. Spray it and you can watch it run off!! It is an absolutely amazing product. The only downfall was that it works on contact so you will have to go back and respray where the solution didn’t cover, therefore using a lot of product. Nevertheless, worth the money and made our pontoon seats look like new!

I got this for a 12 year old pontoon vinyl seats. We kept the seats as clean as expected for years. We live in the Midwest, store the boat for 4 months in the winter, and dock under a canopy. We clean the seats 3-4 times a year good and do some minor wipe downs during the spring pollen months. We started cleaning the seats with a soap and water, then a more mild Awesome from the Dollar Store, then 10 years in we needed to work on some build up spots.This was recommended by our boat dealer. They use it for boats and it works great.It did a great job, but I always stayed away from bleach as it rots the threads. I would use this as directed and rinse good as per the recommendations. I would use this once a year on spots on vinyl seats with threads. Other areas, you should be fine. Just rinse good and follow the instructions.After this harsh treatment, I always use seat protestant with UV to help condition and protect the seats.Seat care may be work and expensive, but so is upholstering seats.

This Star Brite raised the bar significantly for use on a cultured marble shower with caulked joints. Both quick and easy to apply, a short wait, then rinse off for impressive results against mold. The mild to moderate areas look good. Next, I'll target just the problem areas left behind and do a bit of lite scrubbing to help work it in/around thoroughly. Minor scrubbing will remove surface scum/etc. So Star Brite can directly reach the mold that "hid" under it during the first session.I hadn't been impressed with products to clean a shower with caulked joints. I finally stumbled onto a lil bottle of gel which you squeezed along the joints and rinsed off after half a day. In contrast, I sprayed this product on joints and treated the surfaces too, all in a fraction of the time and effort. I rinsed off after 20-30 minutes and was amazed at how much mold it took off. It did its job all over, not just where the line of gel (slowly and accurately applied) touched.I like less effort!

All this is, is just a bottle filled with bleach!