wowstickMini Electric Screwdriver,3 LED Lights, Electric Screwdriver Cordless Rechargeable Set (23)

This thing is super powerful and handy! I highly recommend it for any small electronics. The LED light is extremely bright and is very useful. The charging station makes it convenient as well! A+!

Have been using this frequently to work on keyboards and other small electronics. Easy to use and charge, no frills. Have had no issues with torque when tightening and stops automatically. Would recommend for non-precision work on smaller electronics (anything one may use an iFixit kit with for instance)

In general it works OK. One particular behavior is concerning and may be a warranty defect. When trying to contact support to ask about it, they say visit their contact website. The contact website says to contact them on their global facebook site. Global site responds to contact the USA facebook site. USA facebook site says to contact their global site. Net result is no warranty support. The behavior: after the torque limit is reached and the screwdriver stops, it won't turn or will turn very slowly for 30 seconds or so, even if the driver is not in the screw. Give it a rest and then it works normally.

Works great. Just what we ordered.

The first one of these I ordered had rattling in it like a lose screw, so I had amazon replace it. The second one I got rattled even more, so I took it apart because I really want to keep this in my backpack. After taking it apart completely the rattling was from two silver retaining pins that are supposed to hold the motor casing in place. Put it back together after retrieving the pins and put the pins in the correct spots but they instantly fell out of view but they were still in the channel so I left them. After about an hour of use one of the pins fell out again and lodged itself under the button. I ended up just removing the retaining pins and it has worked fine since with no issues, I'm going to assume this is an issue on almost every model seeing as I am 2 for 2. I have the bigger version of this as well for my desk and it works amazing I would highly recommend that one over this, unless you are comfortable taking this apart and either removing or gluing the pins in place (I would advise not gluing the pins though as it will make a future repair on it very hard). Pins are in the picture.The F1+ is slightly bigger and has a little more power.

Pros:Looks good...Works well...Battery lifeBuilt in light was nice...Felt good in my handsTorque was decent. For a screwdriver being used on PC parts, it did its job...Cons:Was made of thin aluminum, which made it look cheap at a closer glance. It rolled off my coffee table and took a one and a half foot fall onto my floor. That was enough to dent the edge of the pen where the cap slides on which in turn made it permanently difficult to actually put the cap back on.Felt cheaply made. You could feel the edges of the cheap aluminum around the button when you pressed the buttons down. I could ignore that if the whole pen in general didn't just feel cheap.The built in light was nice but don't hope to use it to actually see into tight spaces BEFORE you try aligning the bit to the screw because the light ONLY works when your holding the torque button so seeing where you're placing the bit before the bit starts spinning is out of the question and didn't make sense for a built in light...IMOTorque was good for my electronics needs but If you over tighten or try to loosen a screw thats too tight, the motor grinds and gives off an even cheaper feel as if it didn't already feel cheap. Had to use a regular screwdriver for certain screws which made it a hassle to have to go back and fourth between the two. Lasted through my whole PC build, put it up for a couple days and when I took it back out to use again, the torque just gave out and wouldn't work. Motor was running but bit wasn't turning. Needless to say I had to return it.All in all, I feel like it'll be good for LIGHT electronic work but I wouldn't recommend this product at all. There are better options that don't look or feel as cheap as this product does. Buy it if you want, if you life it, good for you! Its just not for me.

I love this screw driver. Great for working on electronics where the screws don’t need a lot of torque. Lots of bits even some that weren’t in my other kits. I may even order another one that has more bits to help work on game consoles and controllers.

Bought in January of 2022 to help me more efficiently tinker with the dozens of screws in my small collection of mechanical keyboards. At first it worked beautifully. I used it so much it sat on my desk in the little upright stand. In the last few weeks however, it would work very inconsistently. As of December 2022, It's stopped working, and now it's a pricey ornament on my bookshelf.