GemRed Digital Angle Gauge (Aluminum-with Hold Function)

I use this all the time to square up my table saw blade. Seems to be spot on, at least consistent enough for woodworking-- specifically with regard to making 45° and 30° cuts. Simple to use. Since it's magnetized, I store it on the ductwork over my saw and it's always handy.

Easy way to find angels

The angle finder works well. In fact, I was kind of surprised at how much I found myself playing with it. I was "angle finding" all over my workshop garage. It could use a just a little stronger magnet. Of course some materials are not as magnet friendly as others. On my saw blade and and other strongly magnetic materials it was fine. The read out is clear and easy to read. The reset/calibrate is easy to use.I would buy again. The main reason I would buy again is that this tool eliminates my questioning the angle indicator on my saw. Is 40 degrees really 40 degrees. Is 30 degrees really 30 degrees. The quality, fit and finish are all worth it.

Very easy to use. You can set your degree, put it on your piece and move it to an accurate location. It has magnets too. They’re pretty strong.

The media could not be loaded. These little fella rocks. I’m that anal guy that questions everything. I’m not going to do a wood project and HOPE it’s at the correct degree cut. After fine tuning my DeWalt you can see it is spot on. And for those that complain the battery runs out, leave the battery out of the unit when your done with it.

Works like I expected and is a good price.

Very good value

Better money spent on others out there