a18445 Labels Replace for DYMO Rhino 18445 3/4" Permanent Vinyl Tapes Black on White Industrial Label Tapes Compatible with DYMO Rhino 4200 5200 6000 Industrial Label Maker,19mm x 5.5m, 2 Pack

I had the opportunity to use these after the official labels that came with the printer ran out. After about two days in a damp, cold environment, the name brand labels were unwrapping, these stayed tight. Cheaper and better. Doesn't take a rocket surgeon to figure this one out.

I had an issue with the 3/4" labels where the very first label I printed wound itself around the printer's drive roller. It was a bit of a mess, and took some carefully applied brute strength to undo. The 3/4" labels on that cartridge have run fine since then. It may be that the first couple of inches need to be cut off before loading the cartridge into the printer. Overall, they seem to be a great option over the name brand labels. Oh, definitely try the shrink tubing. I was skeptical, but am now a believer!

No noticeable difference from the Dymo tape my label maker came with at only 1/3 the price. I have purchased 3/8, 1/2, and 3/4 sizes. 1/2 is the sweet spot for general use. 3/4 is good for large items and labels you want to see from a distance. 3/8 is best for small things like spice jars. I use it professionally as an installer but have since found uses all over the home and office.

I've been using Aonomi shrink tubing labels and the polyester which have always worked great. I don't know why the 3/4 vinyl are so terrible.

I like that it works just right. Can't ask for much more with these

Took a chance and only ordered the two pack. Not nearly as dark a print as an OEM cartridge.But if they get better, down in the roll, Would probably buy again.Will report back.

They worked like all the others. And the price was unbeatable. I was way too excited to see that I can find them at​ a great price!

Like others have written, the 3/4" labels do not print well. There are gaps in the printing due to the ultra thin printing ribbon having wrinkles and the removable backing crease in the dead center of the product. I tried pre-tightening the ribbon, re-printing the label 4-5x, and I didn't get a single label to print perfectly after numerous attempts. For the very few labels that I said were "good enough", I found that they were delaminating from the cables less than 24 hours later. These will be returned. Its not worth the discounted price. The OEM product is far superior. For what its worth, I purchased the 1/2" labels as well and didn't experience the same troubles printing troubles. Time will tell for the adhesive.

Works without any issue.

Great sticky labels however peeling off the backing is challenging as the fold is not in the middle but lower to the bottom edge making difficult to remove the backing

Just wanted to compare the product with the original and determine if saving a few dollars on OEM is reasonable.Overall not bad, however, the protective film separating line goes at the edge, unlike the original in the center. Original is way more convenient.The main issue: the printer label constantly sticks to the roller, folding under and get's jammed. OEM quality is not worth the time waste.Switching back to the original DYMO.