A96 Mineral White Metallic Tricoat Touch Up Paint Repair Kit Compatible with BMW - DIY Kit Exactly Matches Chips and Nicks

Good stuff!

I found the tube brush quite difficult to control for addressing the small paint defect I was attempting to use it on however, the included separate detail brush performed well. The tube brush would likely be more suitable for larger defects.Unfortunately, I have no experience with the other components of this kit designed for more severe damage. It includes a small tube of bondo-like body filler (referred as "soil filler" or "fill soil" in the instruction sheet), spatula/scraper for filler, a sandpaper, and four pieces of sandpaper labeled as 800. The instructions recommend using320 and 600 grit sandpaper, though these not included in my kit.

I ordered these for touchup on my BMW X5. Perfect match. Easy to use and can fill a chip mark easily. It also buffs out well and can even be used by the amateurs to complete a good touchup job.

Ok .. not as close as thought

The touch up kits is excellent and extremely easy to use. Much needed for the environment I live in. The color is precise. Durable and work well. It pays for itself.

Paint is thin and drips quite a bit. One coat is not enough. Color is not an exact match

Nice easy to apply and matches the actual paint on my car. Drying process it less than two days. I love it and would buy more

Short Version:This product does the job I was hoping it would do. In years past I'd had a very bad view of touch-up paints. I have a much improved view of this product. The airdam of my car (lower bumper, or lip as some would call it) was peppered with stone chips. I saw this product and decided to give it a try. My only REAL hope was that the color was a good match (it hasn't always worked out that way for me). In this case, it was a good match. It did what I wanted, which was to color the chips and in some cases, fill them in a bit. I wasn't looking for perfection, just to make the chips less obvious.I'd rate this less than a 4 but certainly more than a 3. It rounds up to 4.Long Version:This kit comes with a paint vile with a brush built into the cap, a separate short bristle brush (which I think I should have used and will next time), a small rubber sanding block, a very small piece of very fine sandpaper, a small tube of body putty, and an applicator for the putty. While some may use all that, I've personally found in the past that if I'm sanding the paint, I'll just get the panel painted. So I didn't use it. That's just me. Your mileage may vary.The paint, as I already mentioned, was a very good match. Even if I "painted outside the lines (of the chip)" it didn't leave an ugly blotch. I really appreciate this aspect. In my opinion, the paint itself is just a bit too thin for my needs (chip fill). It's nice that it flows well, but on occasion thinned out a bit too much. That was easy to correct with a second coat. But I would have preferred the paint to be just a bit thicker so it didn't thin out when applied. It would have made filling the cracks a bit better. Also, being so thin, the pain occasionally dripped off the brush, or sometimes flowed down the brush and onto my fingers. Otherwise, I'm pleased with this and will almost certainly use it again when the chips reappear.