Fostoria - FES10241CA FES-10241-CA FES Series Heat Wave Portable Electric Salamander Heater, Single Phase, 10KW, 42 Amp

I have to say I was a bit concerned about the price but after doing research on the Dr Heater product and then adding the cost of the power cord, etc. there wasn't the gap I initially thought. Also, the unit draws 41 amps and that's it. I just had a shop built on the property with a high bay door for an RV that we may or may not get. I put a full 50 amp RV panel in the rear. No issues whatsoever. I do have a 36 foot RV extension cord on order so I can put the unit anywhere in the shop including by the partially open roll up door for evening cigars and cognac in the winter. Just be reasonable with it, keep it out of the weather, and it should last a long time. I do recommend two people muscling it around for assembly. Once assembled, it rolls around easily. Also for this particular high current plug, play it safe and turn the breaker off when inserting or removing. As one reviewer pointed out, it doesn't blast heat like a propane tube heater, but going with the long game without fumes in the shop will work out fine. Save the propane unit for power outages with a small generator.

This does not produce heat like a kerosene or propane heater. I purchased this heater mainly because I had to wear ear plugs when using my large kerosene heater in the barn; I could only work out there for so long due to the noise - not very relaxing.This unit gradually heats the area and the thermostat does not raise the intensity of the heat; this concerned me initially until I looked at the manual once again. That being said, the unit is very quiet, east to move around and can be placed close to where you are working. I was expecting something a little more powerful for the price but now after using the heater a few times am quite pleased with it; especially the lack of noise.

As a contractor these are the only heaters I use any more. this is my third one. Works great!

On a job site, this is a great heater. We are often in a position of heat in new build not on and need heat to finish. Recently working on a 3 story 4,000 sq ft home. Put this in the stair well and the whole house is warm enough to work. Would recommend

Purchased this to replace a kerosene heater. I have only used it approx. 32 hours but it puts out a tremendous amount of clean, dry warm heat. We are using it in the final phase of new construction. The "no fumes" makes this a must.

Great heater - safe - will not burn down the house durring construction. They move a lot of air which is great during drywall to help get the moisture out. Quality product.

Had to return it, did not work out for us.

❤️❤️❤️