KOWOODPlus 45 Deg Round Over Router Bit Set, 1/4 Inch Shank, Radius in 1/8”, 5/32”, 3/16”, 1/4”. with Updated Kowood C3 Carbide. Great for Round Edges, Ideal for Table, Drawer or Cabinet Edges

Great value. These do a good job chamfering all kinds of wood. I've done plywood, MDF, Oak and Maple up to 1/4' so far without issue. The bearing is larger in diameter than most chamfering bits I have. This is a good thing for me.

Good bits & value for DIYer.

Bought these because I needed a 3/16" round over bit and that size was included in this set for less than I could buy a single bit. I use that size to make 3/8" dowels of the same species as the rest of the project. These dowels work to make plugs for Kreg pocket holes. My last project was walnut and dowels were not available locally and the cost of ordering dowels and shipping was greater than buying this set. The bit used worked well for this purpose.

I do a little woodworking for myself, but I'm a machinist by trade. I was in a big rush to get an 1/8" rounding-over bit, and my regular suppliers were three days out, so I ordered these, not expecting much, but figured they'd last for the job. The job was chamfering 700 inches of aluminum plate for a project.The bit not only 'held up', it's sharp enough for another 700-1400 inches of work in aluminum, still going strong. They're also accurately made. I _really_ got my money's worth on these cutters, and would buy them again. If they work this well in 6061 aluminum, they've GOT work great on wood!!!L

I've only used the 2 smallest bits to chamfer some hpl on mdf. I ran 80 feet with the smaller bit and about 90 feet with the larger one.I was impressed with the sharpness and durability and lastly the thickness of the carbide. The combination of material that I routed is very abrasive but the bits performed well above their price. I would recommend this kit

Works great on epoxy and wood. Used with my Ryobi battery powered Router.

I only used the quarter inch roundover so far, but it was a massive upgrade from my old harbor Freight carbide bits. That thing cut like butter! I went after some extremely hard wood with grain going every which way. It never chattered, chipped out, burned, splintered, or anything. It just cut smooth as silk. The scrap pieces weren't even prepped, and even had a rough edge for the roller bearing to ride on. Even so, it left an extremely smooth finish with no sanding.

they work well, but I'm a total router newbie that has watched his router go rhoomba on him. lolbe safe as routers are not toys.love the size choices for the 45⁰ bevels.different depths are good by starting small then changing to a larger bit and going in for the finish.that's how I did smoothest work...after getting greedy trying to use one big bit and pushing into the wood hastily in too few passes.Good product.Just think Patience over speed.