Hangar 9Remote Glow Plug Adapter with Starter Adapter HAN3025 Air Field Equip & Electronics

I love these little units, they can be a tad tricky to get sitting correctly on the glow plugs but when they are just right they work really good.Do yourself a favor and get one, save those fingers for flying the sticks.

This is what I’ve been waiting for! Don’t get the Dubro or the Sullivan, or the MPJ. Get this one. It’s boot actually fits on a glow plug without a hassle and clips in very nicely. I was hesitant at first, but decided to try yet another remote igniter setup from a different manufacturer. I’m glad I did. I will buy more for sure. In fact, I may buy a few and put them away for later.Once you install everything, I highly recommend soldering and heat shrinking the brass clip that is on the glow plug lead. Installation and soldering and heat shrinking took about 10 minutes from the time I opened the package to the point of testing.

These things are great.. I use them on every new plane I put together.HOWEVER, the threaded portion of the jack is barely long enough to pass through a piece of 1/8" balsa.I've bought several of these, and one was slightly longer, but the rest are TOO SHORT to do the job without a bit of frustration and trimming the inside of the fuselage.Once you get to the 16" and larger props, I'd consider using one of these, just plan ahead where you'll be placing the jack.

I've been in rc helis for many years, and this particular glow plug clip can't be beat. Very strong, positive grip on the glow plug, the wire length is plentiful, and a low profile on the clip is very nice.

I needed the fittings for my float plane. Yup chopped wires/re-soldered. and used the hardware for a great install.The glow plug connector fits like a glove on my Magnum 52 4S. I mounted the female phone plug on the fuse and the male end is a pigtail to connect the removable wing with engine pod. The back side of the plug goes to my glow driver module.Clean install and that's how we model Folks!!

Really such a great little device especially when you have a motor that scowled then and it's a pain to get at the globe plug

I liked that it kept my fingers out of the propellor but disliked the fact that the input socket had such a short threaded portion that the only place to fit it was through the fibereglass engine cowl. This tends to negate the advantage of keeping fingers away from props. Used on a Hawker Typhoon with an inverted engine. Would have given 5 stars if not for crticisms mentioned. It did do what it was intended for

This solved a problem I was having, fast delivery, correct product, happy customer.