Acouto Motorcycle Luggage Rack M516-B035-BLK M8*25, Rear Luggage Rack Steel Pipe Bracket for Scrambler 400 803, Rear Luggage Storage Rack Carrier Accessories

Shipped with stainless M8 and M10 screws and washers for my 2022 Scrambler Desert Sled.

The holes didn’t line up properly on my Scrambler Icon so I ended up drilling them out some. Otherwise I think it works well.

I tried to mount this on a 23 Scrambler DS. The 4th bolt hole wouldn’t line up. I tried all the usual tricks. This one first, then the others. The others first, then this, all at the same time. Just wouldn’t work.

Not welded properly, ítem cut my hands as it was not finished.

Perfect fit. 10 minute install. Came with bolts and washers. Pulled plugs out of pre-threaded holes on bike frame and installed. No manipulation at all. A+

Firstly I would like to note that I purchased this for my 2022 Urban Motard which is not in the described list of bikes. Reason is the older bikes have M8 weld nuts. Newer bikes have M10x1.5 nuts. I went to THD and purchased some bolts in 25mm length. I really want to like this, and if quality control was better it would get a better review. First issue I had is fitment. The eyelets where they're bolted in are not perfectly aligned with the bolt holes on the bike, again this may be less of an issue on older bikes because the tolorance is greater with smaller bolts. But I noticed the bracket is not at the same height on each side, with the difference being about half an inch (not pictured). The other issue I had was with the horrendous paint application. The end of the bar had a completely different sheen, some spots had orange peel, foreign object ingress, and some straight up scratches. It would look way better if it didn't have these issues!

So I gambled and it worked out. This will fit a 2021 Ducati Scrambler Desert Sled with some pressing and clamping, " not much" The supplied bolt and washers are too small for the 2021, but with the right hardware and a drop of sweat, the rack fits the bike! Tight!!For the quality control guys, you missed a spot! A big spot I guess where you hold the rack to paint it? Had to rattle can and dry before muscling it onto the bike.

Had to grind holes to fit and some of the welds are not complete so you can see rust come out after rain.The part was not prepped before paint they painted over rust and untreated metal.